Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Voltage and current measurement taken for a 3- phase Wye- connected alternator indicate a line voltage of 208 V and a line current of 20 A. What is the value of the phase voltage and phase current?
An RL circuit takes a current of 7A that lags behind the 231-volt source by 35 electrical degrees. Calculate the power factor, impedance, resistance and inductance of the circuit.
A 1cmx2cm rectangular wire loop carries a current of 2A. What is the magnetic field at the center of the rectangle
Sketch magnitude and phase responses (as linear gain versus digital frequencies) for each filter (use [0,π]). Indicate filter type. Find cutoff frequencies if sampling frequency in 30 kHz. Use 6 points only. Do not use MATLAB.
Critical frequency for the input low pass network, and the output low pass network, estimate the values for Cbe, Cjc, Cbc, and Cje. Concider the resistance of the signal sourceRs to be equal to the 1 ohm resister in series with the source.
Develop a logic circuit whose output is high when the input has had three consecutive ones to the input. Overlapping threes are allowed. (e.g., x=011110110 then the output z=000110000 assuming starting state was 0).
The input power to the geenrator is 100hp. When the generator is operating at rated values and unity power factor, the generator is 80% efficient. a.) Find the generator speed in rpm and rad/sec. b.) Find the mechanical torque supplied to the gener..
A single phase transformer has the following rating: 120 kVA, 2000 V/100 V, 60 Hz with 1000 primary turns. Determine (A) the maximum flux. (B) given a maximum flux density of 0.25 T, the cross-sectional area of the core.
consider the following two first-order transfer functions H1 (z) = z + b/z + a , a = 0.3, b = - 0.4 H2(z) = bz + 1/z + a , a = 0.3, b = - 0.4 (a) draw the pole-zero plot for both transfer function H1(z) and H2(z)
It operates at a power factor of 0.85 (lagging) at its rated conditions. Calculate the per-phase current that has to be carried by the cables to the power electronics converter and the step-up transformer located at the base of the tower.
A student acquires a 50mV, 1mA (meter-A) and a 50mV , 2mA (Meter-b) d'arsonval movements and converts both the meters to measure 100v full scale individually. A potential divider consisting of 70k and30k resistors was powered using an ideal 100v D..
Identify the types of system-building methods used by Dorfman to build its wireless warehouse system.
Design a combinational circuit with four inputs, x,y,w, and z, and four outputs: A, B, C, and D. When the binary input value in decimal is 3,8,12 or 15, the binary output value is one less than the input value, otherwise it is one greater than the..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd