Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A temperature sensor covers a range of 0 to 70 degrees C with an output sensitivity of 2 mV/degree C. The sensor is input to an ADC with voltage range of 0 to 4V. What is the value of the feedback resistor required for an inverting amplifier circuit required to interface the sensor? The resistor to the positive op-amp input is 1.0 kohm.
by finding the relevant air analysis, determine the partial pressure of nitrogen in the athmosphere at 1.00bar.f a sample of air at this pressure and 10°C was put nto a rigid container and then itd temperature raised to 91°C, what would be the pre..
How many decimal characters (including a possible minus sign) will be required to represent in decimal, sign-magnitude form numbers which are represented using twos complement 24-bit numbers in binary
a positive-sequence shunt admittance y= j4.4* 10-6 S/km. for this line if it has 70% shunt reactive (inductors) compensation and 40% series capacitive compensation. Half of this compensation is installed at each end of the line.
This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.
A DSSS-CDMA signal has a chip sequence that is 1,000 chips in length. The sequence repeats every millisecond. Define DSSS-CDMA Chip Sequence
This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.
The load on a 460-V, 60-Hz, Y-connected, balance three-phase source consists of three equal Y-connected impedances of 100+j100 ohms, and three equal Delta-connected impedances of 300-j300 ohms. Compute the line current, power, and power factor for..
Bipolar Junction Transistor, A silicon n-p-n bipolar junction transistor is designed with emitter, base and collector doping levels of 10^19cm, 10^15cm and 5*10^17cm, respectively.
The speed of a 10HP, 230V, 1200 rpm separately excited DC motor is controlled by a 1-phase full-wave bridge converter. The rated armature current of the motor is 10 A. The armature resistance is 0.25 Ohm and the armature inductance is 10 mH.
A transmission line with no loss, with Z0= 60 ohms, is operated at 60MHz. The velocity on the line is c. The line is soldered to a ground connection at z=0. Find the input impedance into this line at z= -1.25 meters
Explain and discuss the problems presented by electronic discovery in civil actions and how the law has responded.
C++ Program Help, make a program that will read a file from a disk and will take the first letter of each word and and make that into a sentence.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd