What is the value of resister parallel to the input voltage

Assignment Help Electrical Engineering
Reference no: EM13270227

the input voltage is 20 with phase angle -90 degrees. There is a 5 ohm resistor in series with it. There is a 3 ohm resistor and a j4 ohm inductor in series with each other, and parallel to the input voltage. There is a 4 ohm resistor, a -j13 ohm capacitor, and a 10 ohm resistor in series, which is parallel to the input voltage. The output voltage is measured across the 10 ohm resistor.

Reference no: EM13270227

Questions Cloud

Advantages and disadvantages of oil exploration : Write an essay with a minimum of 900 words about the advantages and disadvantages of oil exploration.
Design a 4 input and 1 output combinational circuit : Design a 4 input, 1 output combinational circuit. the input represents a 4-bit number, N = X3X2X1X0, which ranges from 0 to 15. The output, PN is 1 when N represents a Prime Number, otherwise PN is 0.
How much nitrogen evaporates : A 52g ice cube at its melting point is dropped into an insulated container of liquid nitrogen. How much nitrogen evaporates if it is at its boiling point of 77 K and has a latent heat of vaporization of 200 kJ/kg
What is the internal rate of return of a project : What is the internal rate of return of a project that requires and investment of $1366 today and provides a single cash flow in year 5 of $1945. The appropriate discount rate is 10%.
What is the value of resister parallel to the input voltage : There is a 3 ohm resistor and a j4 ohm inductor in series with each other, and parallel to the input voltage. There is a 4 ohm resistor, a -j13 ohm capacitor, and a 10 ohm resistor in series, which is parallel to the input voltage.
How many grams of the caffeine will extract into the ch22cl2 : If you have 4.26 g of caffeine dissolved in 94.6 mL of water and the extraction coefficient between H2O and CH2Cl2 is 21.51. How many grams of caffeine will extract into the CH22Cl2 layer if you use 59.9 mL
What was the original temperature of the water : A 32.5-g glass thermometer reads 24.1?C before it is placed in 131mL of water. What was the original temperature of the water
Write a module case study applying the hfacs : Review the Factual Information chapter (do not review the Analysis, Conclusions, or Recommendations chapters) of the Full Report (not the Summary).
What will be the firm weighted average cost of capital : The bond issue has a face value of $550,000 and a market quote of 98.0. The company's tax rate is 32 percent. What is the firm's weighted average cost of capital?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine what is the frequency of the waveform

the signal shown below is a sine wave as it might be displayed on an oscilloscope. If it takes 40 msec. for the waveform to travel between the points shown by the arrow "B" below, what is the frequency of the waveform

  Explain the ohmic resistance of the photoresistor changes

A photoresistor is connected series to a battery of 10 V with internal resistance of 5 Ohms. The ohmic resistance of the photoresistor changes by time through the day and expressed as: RLDR=20-(10/t) .

  Find transfer functions of analog and discrete-time filters

The input analog signal is bandlimited to 3900 Hz. The overall frequency response is required to satisfy the following: Gain > -1.33 dB for frequencies less than 1, 333.33 Hz Gain

  Which fet operates in both depletion and enhanced mode

Which FET operates in both Depletion and Enhanced mode and how do you recognize the mode by just looking at the Family of Drain Characteristic Curves

  What should be the line voltage of an ac motor

An AC induction motor is rated at 900 rpm, 200V, 60HZ 3-phase. If reduce the motor speed by reducing the line frequency to 20HZ, what should be the line voltage

  Write while loop that initally will blink an led1 once

Assume one LED (LED1) and one switch input (SW1). Write a while(1) { } loop that initally will blink an LED1 once power is applied. On each press OR release of SW1, alternate between terminating blinking and resumingine the blinking. Draw a state ..

  What is the real power-reactive power and aparent power

A manufacturing plant has a 600V, 60Hz supply and the following loads: Lights: 24kW Electric furnace: 4.8 + j6.4%u03A9 with a current of 150A Motor loads, 160kW at 0.8 Power Factor, lagging.

  Find the magnetic flux density vector at an arbitrary point

The disk uniformly rotates in air about its axis (perpendicular to the disk) with an angular velocity . Find the magnetic flux density vector at an arbitrary point along the axis of rotation. Assume that the charge distribution over the disk remai..

  Find what is the single amount at the end of seven years

what single amount at the end of seven years is equivalent to a uniform annual series of %5000 per year for 12 years if the interest rate is 8% compounded annually

  Compute the maximum torque in nm which the motor can deliver

A 2000 hp, 1.0 power factor three phase Y connected 2300V, 30 Pole, 60Hz; synchronous motor has a synchronous reactance of 1.95 ohms/phase. For this problem all losses may be neglected.

  Determine vaulters altitude as vaulter crosses the bar

A 52-kg pole vaulter running at 12 m/s vaults over the bar. Her speed when she is above the bar is 0.7 m/s. Neglect air resistance, as well as any energy absorbed by the pole, and determine her altitude as she crosses the bar.

  Design interface between a computer output port and em relay

An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs at least 100 mA.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd