What is the transistors emitter current

Assignment Help Civil Engineering
Reference no: EM13563739

1.Ethane gas (C2H6) at 25C is burned with 150% theoretical air at 500 K and 1 atm. Find the heat transfer (in KJ/Kmol)from a steady-flow combustor if the products are at 1000 K and (a) complete combustion occurs; (b) 95% of the carbon is converted to CO2 and 5% to CO.

2.In swamped common-emitter BJT amplifier, as shown below, if Vcc = 12v, R1 = 8.2 k ohm, R2 = 10 k ohm, Rc = 500 ohm, Re = 1 k ohm, and Beta = 100, what is the transistor's emitter current?

Reference no: EM13563739

Questions Cloud

What is the minimum chain length for the application : A motorcycle sprocket on the rear wheel has a diameter of 24 cm, and trhe driver sprocket has a diameter of 4.0 cm. The driver sprocket shaft and rear axle are 60 cm apart. What is the minimum chain length for the application.
Determine the number of truck loads required to obtain : For construction of an embankment, the soil is transported from a borrowed area using a truck which carries 5.5 m^3 of soil at a time, with the following details: For the Borrowed Pit: bulk unit weight= 16 KN/m^3
Has the issue of having time not wasting become a parvasive : The plant manager has a decision to make. She needs to reduce the concentration of salt in the 8000- gallon tank from 30000 mg/L to 1000 mg/L. she can do it in one of two ways.
Prove that any polygon admits a triangulation : Prove that the smallest angle of any triangulation of a convex polygon whose vertices lie on a circle is the same. This implies that any completion of the Delaunay triangulation of a set of points maximizes the minimum angle.
What is the transistors emitter current : Ethane gas (C2H6) at 25C is burned with 150% theoretical air at 500 K and 1 atm. Find the heat transfer (in KJ/Kmol)from a steady-flow combustor if the products are at 1000 K and (a) complete combustion occurs; (b) 95% of the carbon is converted to C..
How does the nature of the boundary layer affect lift : Sitting on the deck one evening. watching for that pesky bunny, jon and his brother see a twig floating down from an aspen tree. (wait - os that a bunny ?) they wonder just what the boundary layer looks like on the twig.
At what angle should the pilot direct the aircraft : A small aircraft A is about to land with an airspeed of 80 mi/hr. if the aircraft is encountering a steady side wind of speed vw=10 mi/hr as shown, at what angle
What should be the dimensions of the channel : A trapezoidal channel is to design to carry a discharge of 75 m3/s at maximum hydraulic efficiency. The side slope of the channel is 2 H/1 V at the left and slope of right side is 3H/1V. The Manning n value is 0.030.
Deteremine the maximum in-plane and out-of-plane shhear : A pressurized steel tank has a radius r=0.6m, a wall thickness t=18mm and an internal pressure p of 2.8 MPa.The steel has a modulus of elasticity E of 200 GP and a poissons ratio 0.30.Determine the hoop and axial stressses

Reviews

Write a Review

Civil Engineering Questions & Answers

  The pavement currently exhibits low to medium and localized

The pavement structure consists of 160 mm of hot-mix asphalt (HMA), 150 mm of granular base and 450 mm of subbase placed over silty clay subgrade. The pavement is 20 years old and its current PCI is 50. The pavement currently exhibits low to medium a..

  Calculate the elastic recovery

A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load.

  What is the retention time for this lake

A small lake with volume of 20,000 m^3 has no natural pollutant sources. However, a sewage pipe discharges sewage containing an organic polluntant into the lake. Conditions in the sewage pipe are Qs= 0.5 m^3/s, and Cs= 100mg/L.

  A sewage treatment works stw

A sewage treatment works (STW) with 4 single-stage trickling filters has become organically overloaded due to the discharge of a biodegradable industrial effluent to the STW. This is causing effluent to pond on the surface of the filters.

  What is the station of the pt

a horizontal curve on a single-lane highway has its PC at station 124 + 10 and its PI at station 131 + 40. The curve has a superelvation of 0.06 ft/ft and is designed for 70 mi/h. What is the station of the PT?

  Calculate ground-level concentration downwind and crosswind

At noon on a sunny summer day with a surface wind speed of 4m/s, SO2 is released over rough terrain from a 90m stack at a rate of 400g/s. Assume that the plume rise is 60m.

  Estimate the minimum absolute pressure that can develop

When water at 70C flows through a convergingsection of pipe, the pipe pressure decreases in the direction of flow. Estimate the minimum absolute pressure that can develop without causing cavitation.

  Dimensions of symmetrical trapezoid plate

The plate is submerged in a liquid is a vertical position with the parallel sides horizontal and the shorter parallel side at the top and exactly in the surface of the liquid.

  Derive the pollutograph and the loadograph

The average P concentration in the runoff if the overall (agricultural and residential areas) runoff coefficient = 0.4, 40% of P is removed from the agricultural area by rainfall, and 90% of P is removed from the residential area by rainfall.

  What is highest possible final grade in nighttime conditions

An equal-tangent sag curve has its PVI at station 10+00 and elevation at 138 ft. Directly above the PVI the bottom of an overpass structure is at elevation 162 ft. The PVC is at station 4+00. If the initial grade is -4.0%

  Determine the force exerted on the cable by the man

The man has a mass of 75 kg, and the beam has a mass of 40 kg. The beam is in equilibrium with the man standing at the end and pulling on the cable. Determine the force exerted on the cable by the man and the reactions at pinned support C.

  Determine how many balloons would be taken

To float a 160 pound man using helium balloons (assume 0.52 cubic feet per inflated balloon). How many balloons would it take. Assume density of air is 1.29 kg/cubic meter and the density of helium is 0.179 kg/cubic meter.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd