What is the thermal and mechanical efficiency

Assignment Help Mechanical Engineering

Reference no: EM13720679

What is the thermal and mechanical efficiency for this engine when used as heat pump and refrigerator with the following propties;

Temperature difference (with respect to 21° C): Refrigerator: -4 K (reservoir: +6 K) Heat pump: +13 K (reservoir: -1 K)

Power varies (1_4)W

RPM varies (1000_650)

Generator voltage=6 V

Reference no: EM13720679

Questions Cloud

Determine the overall heat transfer coefficient U : A deep freezer for hazardous chemicals is to be maintained at -20oF to insure a safe environment for the chemicals. The freezer is in a room that is kept at 60oF, and the inner and outer walls of the freezer are made of 26-gauge (0.0184-in) steel.

Determine the K-values from a DePriester chart : A stream containing 57 mol % n-Octane and the remainder Ethylene is to be separated by flash distillation. The molar flow rate of the stream is 823 mol/hr. The temperature and pressure of the stream entering the flash drum are 105°C and 325 kPa. De..

Drum pressure and drum temperature : A feed that is 50 mol% methane, 10 mol% n-butane, 15 mol% n-pentane, and 25 mol% n-hexane is flash distilled. F=150 kmol/h. Drum pressure =250 kPa, drum temperature =10 degrees celcius. use the depriester charts. find V/F, xi, yi, V, L.

Calculate the cost per piece of a milling operation : Calculate the cost per piece of a milling operation that is used to machine a pocket of 2”x3”x0.5” (LxWxD). The material being machined is high silicon aluminium. The tool material is PCD.

What is the thermal and mechanical efficiency : What is the thermal and mechanical efficiency for this engine when used as heat pump and refrigerator with the following propties;

Determine the power required to drive the pump : A water pump is required to pump 0.23ft3/sec of water at 60F at atm up to 100psi gage. of the pump has an estimated isentropic efficiency of 50%, determine the power required (HP) to drive the pump.

Calculate the entropy change of the two reservoirs : Heat in the amount of 100 kJ is transferred directly from a hot reservoir at 1200 K to a reservoir at 600 K. Calculate the entropy change of the two reservoirs and determine if the increase of entropy principle is satisfied.

What is the minimum temperature rise possible : Air at 14.7 psia and 70 degrees Fahrenheit is compressed adiabatically by a centrifugal compressor to a pressure of 100 psia. What is the minimum temperature rise possible? Explain.

Dimensional wall of material : A one dimensional wall of material (Kw=10w/mk) is 50 mm thick with uniform heat generation q‘‘‘=5*10^6w/m^3. The left side is exposed to a fluid hl=500w/m^2k at 20 degree Celsius. The right side has a 10mm thick plate attached that has no heat genera..

User Account

All Pages