What is the temperature of the small vessel at the end

Assignment Help Civil Engineering
Reference no: EM13321033

A small nitrogen container is at Pressure P1 = 5 bar and T1 = 300 K. It's been filled from a larger nitrogen container, which is P= 10 bar and T = 300 K. The filling process ends when pressure in the small container is Pf = 10 bar. What is the temperature of the small vessel at the end of the filling process? Nitrogen can be considered ideal with Cv=5R/2, independent of temperature.

Reference no: EM13321033

Questions Cloud

Determine the temperature of propane in the tank drops : determine the temperature of propane when the pressure in the tank drops to 1 atm. Also determine the total amount of heat transfer from the environment to the tank to vaporize the entire propane in the tank.
Determine whether the crystal structure for the alloy : If the densities of metals A and B are 4.27 and 6.35 g/cm3, respectively, whereas their respective atomic weights are 61.4 and 125.7 g/mol, determine whether the crystal structure for this alloy is simple cubic
Determine the acceleration of the proton : A proton is projected in the positive x direction into a region of uniform electric field Earrowbold = (-5.40 multiplied by 105) i hat bold N/C at t = 0. Determine the acceleration of the proton
Calculate the speed of each particle : An electron and a proton are each placed at rest in a uniform electric field of magnitude 556 N/C. Calculate the speed of each particle 47.6 ns after being released
What is the temperature of the small vessel at the end : A small nitrogen container is at Pressure P1 = 5 bar and T1 = 300 K. It's been filled from a larger nitrogen container, which is P= 10 bar and T = 300 K.
What constant force must the athlete exert on the ball : The ball thrower, who has a mass of 100 kg, can throw a 500 g ball with a speed of 10 m/s. What constant force must the athlete exert on the ball
Estimate the annual et losses in inches for the area : For a drainage area of 5,187mil^2 mean annual runoff is determined to be 3,708ft^3/s and the annual averge rainfall is 35.5 inches. Estimate the annual ET losses in inches for the area.
Explain aluminum reacts with oxygen to yield aluminum oxide : Aluminum reacts with oxygen to yield aluminum oxide. If 5.0g of AL reacts with 4.45g of oxygen what is the empirical formula of aluminum oxide
What is the apparent length of the beetle : A beetle 4.80mm is examined with magnifier of focal length 10.3 cm. If the observer's eye is relaxed while using the magnifier, what is the apparent length of the beetle

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what ph is required to precipitate of iron

what pH is required to precipitate all but 0.20 mg/L of iron from a raw water with an Fe 3+ concentration of 2.1 mg/L Assume the temperature is 25 C. The reaction isFe(OH)^3 = Fe + 3 OH^- and pKs= 38.57

  How far upstream is depth within 100mm of uniform depth

A dam located in a channel of rectangular cross-section which carries water flowing at a rate of 8.75m3/s. The depth of water upstream of the dam is 2.5m. the channel is 5m wide,

  Determine the normal and shear stresses

The grains of wood in the board make an angle of 20 degrees with the horizontal as shown. Determine the normal and shear stresses that act perpendicular and parallel to the grains if the board is subjected to an axial load of 250 N.(Dimensions l=3..

  Determine the maximum and minimum stress intensities

Determine the maximum and minimum stress intensities in the section.

  Determine what is the rate of flow into the reservoir

Runoff from a storm flows into a reservoir with a surface area of 20.0 ha at a constant rate. The reservoir level is observed to rise at 1 mm per minute when water is being released through the dam at a rate of 10 m3 per second.

  Calculate what is the peak discharge at the reach outlet

Use the Muskingum method to route a flood through a reach a river. The base flow is 100 cfs, and the incoming flood flow increases 50 cfs every 2 hr over a 6 hr period and the subsides at the same rate.

  Find the frictional resistance of the ram is engaged

If the rate of travel of the ram u is 0.5 fps, find the frictional resistance, F when 6 ft of the ram is engaged in the cylinder.

  Determine what is the magnitude of fb for the requirement

The cables A and B exert forces FA and FB on the hook. The magnitude of FA is 100 lb. The tension in cable B has been adjusted so that the resultant of the two forces is oriented perpendicular to the wall to which the hook is attached.

  What is the height of the lighthouse above sea level

An observer standing on a beach can just see the top of a lighthouse 15 miles away. The eye height of the observer abouve sea level is 5.7 feet. what is the height of the lighthouse above sea level

  Describe does the sample meet the niosh standard

The National Institute for Occupational Safety and Health (NIOSH) sets standards for CCl4 in air at 12.6 mg/m^3 of air (a time average over 40 hr). The CCl4 found in a sample is 4800 ppb. Does the sample meet the NIOSH standard

  Determine what concentration of ozone should be injected

A water supplier wants to inject ozone into a piper bringing water to the water treatment plant to predisinfect the influent. The 3.0-ft diameter piper is 3,400 feet long with a steady flow rate of 10,000 gal/min.

  Discuss the advantages and disadvantages of attached growth

Biological treatment processes for wastewater can be catogarised as dispersed growth and attached growth systems. Discuss the advantages and disadvantages of attached growth systems over dispersed growth systems.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd