Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Assume that we make an enhancement to a computer that improves some mode of execution by a factor of 10. Enhanced mode is used 50% of the time, measured as a fraction of the execution time when the enhanced mode is in use. Recall that Amdahl's law depends on the fraction of the original unenhanced time that could make use of the enhanced mode. Thus we cannot directly use the 50% measurement to compute speedup with Amdahl's law.
(a) What is the speedup we have obtained from fast mode?(b) What percentage of the original execution time has been converted to fast mode?
An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs at least 100 mA.
An input signal of 10V at 0degrees and a frequency of 1592Hz is applied to a series RLC circuit with resistor R=100ohm, inductor L= 40mH, and a capacitor C=0.5uF. The value of the total circuit complex impedance is
If the data stream is transmitted using a bandwidth of 64 kHz in an ordinary system (without spread spectrum), what is the SNR that could be tolerated without experiencing significant errors
Built-in voltage for a Si p-n junction is tested to be 0.6 V, NA = 2 X 10^15 cm^-3 on p side. Find ND on n side. (Assume ni = 1 x 10^10 cm^-3; and k*T/q= 0.026 V)
Consider a PNP BJT optimum designed for low voltage high current gain. (a) Draw energy band diagram with proper labeling with VCB= -0.7V, VEB= 0.7V. Which mode is the BJT operated in (b) Plot excess minority charges stored in each region with pro..
where the assigned loop current leaves the voltage source. If current leaves the voltage source at its positive terminal, the voltage would be positive and if it leaves the voltage source at its negative terminal,the voltage would be negative.
A four-pole three-phase synchronous generator has Xs = 1.82 per unit and ratings of 60 Hz, 24 kV, and 650 MVA. The generator operates at the following point: 60 Hz, armature voltage of 24 kV, output apparent power of 650 MVA
Using the LM555 data sheet, make an estimate of the maximum fundamental operating frequency in the astable mode.
A 100 hp, 3 phase induction motor, operating at the rated load, runs at 423 rpm when connected across a 450 V, 60Hz supply. The slip at this load is 0.06. Determine A). Synchronous Speed B). Number of stator poles
a. A point is equally likely to fall anywhere on the semi-circle defined by the equations, x^2+y^2=1, y>=0. Find the pdf of the y-component of the point's position. b. A point is equally likely to be found anywhere on the surface
The (uniform) area density of defects for a CMOS fabrication process is 0.1 cm-2. Estimate the yield for integrated circuits with the following dimension: 4mm x 4mm, 6mm x 8mm, and 9mm x 12mm.
Discuss the different analog-to-digital converter (ADC) types and configurations. What is the purpose of the ADC. How do you interface to the different configuration
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd