What is the speed of the water leaving the end of the hose

Reference no: EM13691399

Solve the given parts of following question:

Question: Water flowing through a garden hose of diameter 2.73 cm fills a 21.0 L bucket in 1.50 min.

Part I: What is the speed of the water leaving the end of the hose?

m/s

Part II: A nozzle is now attached to the end of the hose. If the nozzle diameter is one-third the diameter of the hose, what is the speed of the water leaving the nozzle?

Please use as much detail as required in your answer. Thank you.

Reference no: EM13691399

Questions Cloud

What is the area of the loop : A uniform magnetic field is at right angles to the plane of a wire loop. The field decreases by 0.15Tin 1.0 x 103 s, What is the area of the loop

What would be the average emf : A square loop of wire with sides of length 44cm is in a uniform magnetic field perpendicular to its area. What would be the average emf if the sides of the loop were only 22cm

What is the magnitude of the average emf induced in the coil : A coil has 250 turns enclosing an area of 10.1cm2. What is the magnitude of the average emf induced in the coil

What is the minimum pressure at which the water pumped : Water is pumped from the Colorado River to supply Grand Canyon Village, located on the rim of the canyon. What is the minimum pressure at which the water must be pumped if it is to arrive at the village

What is the speed of the water leaving the end of the hose : Water flowing through a garden hose of diameter 2.73 cm fills a 21.0 L bucket in 1.50 min. What is the speed of the water leaving the end of the hose

Determine the speed at which the water leaves the hole : A large storage tank, open at the top and filled with water, develops a small hole in its side at a point 16.4 m below the water level. Determine the speed at which the water leaves the hole

Calculate the absolute pressure at the bottom : Calculate the absolute pressure at the bottom of a freshwater lake at a point whose depth is 24.0 m

What is the magnitude of the downward acceleration : Two metal disks, one with radius R1 = 2.50cm and mass M1 = 0.900kg and the other with radius R2 = 4.90cm, What is the magnitude of the downward acceleration of the block after it is released

What can you conclude about the influences of the slit width : From you superimposed single and double slit patterns, what can you conclude about the influences of the slit width, and the slit separation, or the double slit pattern

User Account

All Pages