What is the speed of the package when it hits the ground

Assignment Help Electrical Engineering
Reference no: EM13247146

A relief airplane is delivering a food package to a group of people stranded on a very small island. The island is too small for the plane to land on, and the only way to deliver the package is by dropping it. The airplane flies horizontally with constant speed of 200 mph at an altitude of 950 m . The positive x and y directions are defined in the figure. For all parts, assume that the "island" refers to the point at a distance D from the point at which the package is released, as shown in the figure. Ignore the height of this point above sea level. Assume that the acceleration due to gravity is = 9.80 m/s^2 .

Part 1. After a package is ejected from the plane, how long will it take for it to reach sea level from the time it is ejected? Assume that the package, like the plane, has an initial velocity of 200 mph in the horizontal direction.

Part 2. If the package is to land right on the island, at what horizontal distance from the plane to the island should the package be released?

Part 3. What is the speed of the package when it hits the ground?

Reference no: EM13247146

Questions Cloud

What is the required resistivity and impurity : A bar of p-type silicon, has a cross-sectional area A = 10-6 cm2 and a length L = 1.2 x 10-3 cm. For an applied voltage of 5V, a current of 2mA is required. What is the required (a) resistance, (b) resistivity, and (c) impurity doping concentratio..
Defien how iron and oxygen react to form iron oxide : Iron and oxygen react to form iron(III) oxide; 4Fe(s)+3O2(g)-->2Fe2O3(s). Determine the limiting reactant in each of the following mixtures of reactants: a) 2.0 mol of Fe and 6.0 mol of O2. b) 5.0 mol of Fe and 4.0 mol of O2. c) 16.0 mol of Fe and..
Design low pass active filter with a cutoff frequency : Design low pass active filter with a cutoff frequency t at 10kHz or more by 30db and have the pass band gain positive that does not deviate from 20db by more than 3db. The pass band frequency needed is 800Hz and below Derive transfer function
Find the exit temperature od condenser : Cooling water from a river flows through the condenser (the low-temperature heat exchanger) at the rate of 1.2×108L/h (?30 million gallons per hour). If the river water enters the condenser at 18?C, what is its exit temperature
What is the speed of the package when it hits the ground : After a package is ejected from the plane, how long will it take for it to reach sea level from the time it is ejected Assume that the package, like the plane, has an initial velocity of 200 mph in the horizontal direction.
Explain iron and oxygen react to form iron oxide : Iron and oxygen react to form iron(III) oxide; 4Fe(s)+3O2(g)-->2Fe2O3(s). Determine the limiting reactant in each of the following mxtures of reactants
Compute the equilibrium concentration of oh- : If the equilibrium concentration of Cd2+ ion is 1.5 X 10-6 M, calculate the equilibrium concentration of OH- in an aqueous equilibrium between solid Cd(OH)2 and its ions. (Ksp for Cd(OH)2 is 2.5 X 10-14)
What should be the line voltage of an ac motor : An AC induction motor is rated at 900 rpm, 200V, 60HZ 3-phase. If reduce the motor speed by reducing the line frequency to 20HZ, what should be the line voltage
Find the potential difference applied to the circuit : a cicuit with a 112.0 m aluminum wire, with a diameter of 0.182 mm, what is the potential difference applied to the circuit after the wire is cooled

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd