What is the shortest height it should be

Reference no: EM13544544

An engineering student has been given the assignment of designing a hydraulic holding system for a hay baling system. The system has four cylinders with 120 mm diameter pistons with a stroke of 0.320 m. The lines connecting the system are 1 cm id (inside diameter). There are 15.5 m of lines in the system. For proper design the reserve tank should hold a minimum of 50 percent more than the amount of hydraulic fluid in the system. If the diameter of the reserve tank is 30.48 cm, what is the shortest height it should be?

Reference no: EM13544544

Questions Cloud

Notch fracture toughness show your supportin calculations : A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. the average values of the test results at four different test temperatires were found to be

How far from shore is a sailboat when the top of its 8m : How was this answered reached? what equation was used? equation of a line? could you please explain how the answer was reached and a detailed explanation of the math behind it.

Determine the youngs modulus of the steel alloy and the : a round steel alloy bar with a diameter of 0.75 in and a gauge length of 3.0 in was subjected to tension, with the results shown in the accompanying table. using a computer spread sheet program

Determine the braking efficiency of car : Two cars are traveling on level terrain at 60 mi/h on a road with a coefficient of adhesion of 0.8. The driver of car 1 has a 2.5-s perception/reaction time and the driver of car 2 has a 2.0-s perception/reaction time

What is the shortest height it should be : An engineering student has been given the assignment of designing a hydraulic holding system for a hay baling system. The system has four cylinders with 120 mm diameter pistons with a stroke of 0.320 m

Select a hydraulic pump size and a hydraulic cylinder size : An engineer is designing a hydraulic lift with a capacity of 10 tons. the moving parts of this lift weigh 1000lbf. the lift should raise the load to a height of 6ft in 20 seconds. This will be accomplished with a hydraulic pump

The given data show the result of a model known : The given data show the result of a model known as stopping sight distance, used by civil engineers to design roadways speed(mph) stopping sight distance(ft)

Design and detail the steel reinforcement for the section : The beam has a rectangular section which is to be singly reinforced. Given pt=1.1% design and detail the steel reinforcement for the section where the moment is maximum

To keep cells at 55 degrees : To keep cells at 55 degrees? Why or why not?

User Account

All Pages