What is the saturation current and surface leakage current

Assignment Help Electrical Engineering
Reference no: EM13228154

A silicon diode has a reverse current of 5 uA and 25 degrees celcius and 100uA at 100 degrees celcius. What is the saturation current and surface leakage current at 25 degrees celcius?

Reference no: EM13228154

Questions Cloud

What is the after-tax investment value of the machine : A corporation purchased a machine for $60,000 five years ago. It had an estimated life of 10 years and an estimated salvage value of $9,000. The current book value of this machine is $22,500. If the current market value is $40,000.
Explain and balance an equation : Complete and balance an equation describing each of the above reactions. (Use the lowest possible coefficients. Omit states-of-matter in your answer.)
Explain what is the equivalent uniform annual cost : Machine A was purchased three years ago for $10,000 and had an estimated market value of $1,700 at the end of its 10-year life. Annual operating costs are $1,350. The machine will perform satisfactorily for the next seven years.
Explain the average pressure in the column : The bottom product is to contain 95% of the n-butane in the feed. The average pressure in the column is
What is the saturation current and surface leakage current : A silicon diode has a reverse current of 5 uA and 25 degrees celcius and 100uA at 100 degrees celcius. What is the saturation current and surface leakage current at 25 degrees celcius
Analysis of the organisation using the metaphors : Select an organisation of your choice and critically analyse it using two different metaphors. You should present your organisational analysis in a written essay.
Explain a different substitution reaction that should yield : None of the desired ether was obtained. What product was formed and why did this route to the ether fail? Suggest a different substitution reaction that should yield the desired product.
Write formula for the magnetization volume current density : Write the formula for the magnetization volume current density J M and magnetization surface current density JMS in terms of magnetization vector M. 4. A sphere has permanent magnetization where is a positive constant.
State what is its molar mass : A sample of a gas weighs 2.006 g and has a volume of 1060.0 mL at 795.0 torr and 32.0 degrees Celsius. What is its molar mass?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the angle at the maximum instantaneous current

A purely inductive load of 10 ohms is connected to an ac source of 120 V (rms) through a half wave SCR circuit. a. If the SCR is triggered at 90 degrees, calculate the angle at the maximum instantaneous current.

  Calculate the generation rate of e-h pairs per unit volume

Silicon has an absorption co-efficient of 850 cm-1 at a wavelength of 805 nm. Light of intensity 1 W/m2 at this wavelength is directed at normal incidence onto a polished silicon wafer of thickness 0.5 mm.a. Assuming a top surface reflectance of 30..

  Develop a sensor circuit using commodity components

ETEC 6414 Sensors and Wireless Communications, Assignment 1(a) –Sensor Circuit,  Develop a Sensor Circuit using commodity components

  Define discrete sequence plot in matlab

Discrete sequence plot in Matlab, Consider the following formula, x[n] = x[n-1] + x[n-3] n>=3, find the rest of the sequence for 0

  Find the overall gain gv and the equivalent circuit

Two amplifiers(CS) connected in cascade. The input voltage to the first stage has a source voltage Vsig and Rsig= 100KOhm. Rv=10KOhm AND IS CONNECTED TO THE DRAIN OF THE SECOND STAGE. BOTH TRANSISTORS HAVE Id=.25mA and Vov=.25V

  What is the theoretical thermal noise level

Earth-based 802.11a or 802.11g wireless LAN standards transmit data using a bandwidth of 16.56 MHz. What is the theoretical thermal noise level (in V) in an ideal receiver operating with an input impedance of 50 ohms

  What information is provided in each of the three bytes

1. A signal with a range of 0-12 V is sampled with an 8-bit ADC. What is the change in voltage (delta) between digitized levels 2. Using the SPI, we send three bytes to the LTC2600 DAC. What information is provided in each of the three bytes

  Define binary pcm system

The signal m(t)=6sin(2*pi*t) volts is transmitted using 4-bit binary PCM system. The quantizer is of the midriser type, with a step size of 1v

  Explain a certain cache has an access time

A certain cache has an access time of 2 nanoseconds and a hit percentage of 95%. If the main memory access time is 8 nanoseconds, what is the average access time for a read operation?

  Attenuation of received power with change in transmission

Attenuation of received power with change in transmission frequency and distance between the antennas

  Calculate the distance

Calculate the distance, D at which communication from the space craft will be lost again? Assume both antennas are ideal.

  What is the worst-case propagation delay for the circuit

Design a 4-bit circuit for 2s-complement, base on the formula below, using only inverters, 2 input AND gates and 2 input OR gates. Design your circuit to be as fast as possible. What is the worst-case propagation delay for this circuit

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd