What is the rolling resistance of the road

Assignment Help Civil Engineering
Reference no: EM13561465

A CAT 834H (rubber tires, high pressure), with an operating weight of 103,849 lbs, is pulled up a road whose slope is +3.0% at a uniform speed. If the average tension in the towing cable is 6,060 lb, what is the rolling resistance of the road? This would be what type of road surface?

Reference no: EM13561465

Questions Cloud

Determine the volume of stone required for each filter : A two stage high rate trickling plant is to treat a municipal wastewater having a flow of 2.0mgd. pertinent data: influent BOD5 = 200mg/l, BOD5 removal by primary clarifier = 33%, filter bed depth = 5 to 7ft,
How long until the concentration is reduced : The Fluoride feeder runs out of feed solution. The rapid mix tank is connected to a 5 km long distribution pipe. The flow rate into the tank mix tank is 0.44 m?/s and the volume of the tank is 2.50 m?.
Determine the force supported by the hydraulic cylinder : A Steel plate weighing 205 lb with a center of gravity at point G is supported by a roller at point A,a bar DE, and a horizizontal hydraulic cylinder BC. Negelcting all weights of all members except for the plate,
What is the maximum acceleration from rest of the car : A car has a 10-ft wheelbase (L). the center of gravity is 18 inches about the ground and 5 ft behind the front axle. The weight of the car is 2500 lb. mechanical efficiency if the drivetrain is 85%. and the wheel radius is 15 inches
What is the rolling resistance of the road : A CAT 834H (rubber tires, high pressure), with an operating weight of 103,849 lbs, is pulled up a road whose slope is +3.0% at a uniform speed. If the average tension in the towing cable is 6,060 lb,
How much does the choice of the distribution affect : On a single graph, plot the PDFs if E is assumed to be normally, lognormally, and gamma distributed.  Plot the PDFs for E values between 10,000 and 50,000 kips/in2.  Make sure to label the axes and use a legend to label the curves.
Estimate the electrical power in watts that needs : A small town produces 0.15 MGD of wastewater. How many acres in size would an aerated lagoon need to be to treat this wastewater assuming a depth of 8 ft. and a detention time of 6 days? (7.48 gal/ft^3 ; 43,560 ft^2/acre)
What are the basic assumptions of the traffic flow model : Two 25-kip loads are maintained 6 ft apart as they are moved slowly across the 18-ft beam ab. write a computer program and use it to calculate the bending moment under each load and at the midpoint c of the beam for values of x from 0 to 24 ft at int..
Watch starwood: supply chain strategy : Watch “ Starwood: Supply Chain Strategy ” and read the video Case “Sourcing Strategy at Starwood” at the end of Chapter 12 in the textbook. Also review other source materials, including your textbook, related specifically to Starwood or other organiz..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the compressive strengths of the following

Determine the compressive strengths of the following

  Determine the minimum height on the wall from hose

Determine the minimum height on the wall to which the firefighter can project water from the hose, so that the water strikes the wall horizontally. The speed of the water at the nozzle is Vc=48ft/s.

  Find the magnitude and depth of the point of application

Find the magnitude and depth of the point of application of the force on the circular gate shown (circular gate at an angle of 60 deg.) if h(distance from top of gate to top of water)=5ft. and D(length of the gate)=4 ft.

  What is the carbon concentration at 4 mm below surface

A 1045 steel will be heat treated in air at 900 C. What is the carbon concentration at 0.4 mm below the surface after 6 hours

  Which will cause reaction at the bearing to be equal to zero

Determine the magnitude of which will cause the reaction at the bearing to be equal to zero. The bearings are in proper alignment and exert only force reactions on the rod. Set = 600 .

  The saturated unit weight gammasat of the sand is 200 knm3

a 5 inch inside diameter well is to be placed to a total depth of 60 m in an unconfined sand aquifer. the saturated

  How to determine the diameter of a drilled shaft pile

Using 1630.56 kN as the ultimate capacity determine the diameter of a drilled shaft pile that would have the same ultimate capacity and depth embedment (11.5 m) using the FHWA method. Neglect shaft resistance. Use a F.S. of 2

  A beam is made by bonding a brass core to a steel tube and

a beam is made by bonding a brass core to a steel tube and is subjected to a bending moment as shown. knowing that b

  Compute atomic packing factor for diamond cubic crystal

Assume that bonding atoms touch one another, that the angle between adjacent bonds is 109.5, and that each atom internal to the unit cell is positioned a/4 of the distance away from the two nearest cell faces.

  Compute the probable settlement of the building

The construction of a multi storied building started in January 1989 & was completed in June 1990. The total consolidation settlement of the building was estimated to be 8 cm.

  Question in structure analysis concrete column with

question in structure analysis concrete column with dimension square 300 mm300 mm length 3m and concrete grade c3545.

  Determine the velocity and acceleration of point c of belt

determine the velocity and acceleration of point C of the belt, (a) immediately before the power is turned off. (b) 9 s later.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd