Reference no: EM13706812
A plastic was stretched initially from 30 mm to 35 mm and then released at room temperature. The length changes with time were obtained as the following. Assume the Voigt model can be applied for this mechanical behavior.
Time (hr) - 0, 1, 3, 7.5, 12
Length (mm) - 35.000, 32.509, 30.632, 30.113, 30.028
A) What is the retardation time (hours)?
B) What is the strain (%) after 75 minutes?
C) What percent of the initial strain is recovered after 75 minutes?
D) How long does it take for 50% of the strain to be recovered?
E) If the test was made at body temperature, would you expect the recovery to be faster, slower, or the same compared to the room temperature test?
|
Find the horizontal distance the ball would travel
: A small steel ball bearing with a mass of 16.0 g is on a short compressed spring. Calculate the horizontal distance the ball would travel
|
|
Share your past experiences with some of these pre-writing
: Share your past experiences with some of these pre-writing approaches. Compare and contrast what went well versus what didn't go so well. What have you found that works best as you develop your topic?
|
|
Find the rock velocity as it hits the bottom of the hole
: A rock is tossed straight up with a velocity of 20 m/s When it returns, it falls into a hole 10m deep.What is the rock's velocity as it hits the bottom of the hole
|
|
How high up is bob
: Bob has just finished climbing a sheer cliff above a beach, and wants to figure out how high he climbed. How high up is Bob
|
|
What is the retardation time
: A plastic was stretched initially from 30 mm to 35 mm and then released at room temperature. The length changes with time were obtained as the following. Assume the Voigt model can be applied for this mechanical behavior.
|
|
Be thorough in responding to the writing prompts
: Be thorough in responding to the writing prompts (plan a minimum of 75 words for each question with examples from the text, where appropriate, and demonstration of academic language usage). Cite any sources, other than your opinion, that yo..
|
|
Satisfy the continuity equation
: Consider an incompressible 2D velocity field where u =-2xy and y = x^2-y^2 in Cartesian coordinates. Is it a valid 2D flow (satisfy the continuity equation)?
|
|
Evaluate how tall is the building
: A 0.48 kg rock is projected from the edge of the top of a building with an initial velocity of 11 m/s at an angle 49 degree above the horizontal. How tall is the building
|
|
Principal normal and shear stresses by solving eigen value
: Write a MATLAB program that takes an input of the stress state in 3D. The program should Create the stress tensor. Calculate the principal normal and shear stresses by solving the Eigen value problem.
|