What is the resulting overall voltage gain of cb amplifier

Assignment Help Electrical Engineering
Reference no: EM13274332

A CB amplifier is operating with R load = 10 kiloohms, Rc = 10 kiloohms, and R signal = 100 ohms. At what current Ic should the transistor be biased for the input resistance Rin to equal that of the signal source? What is the resulting overall voltage gain? Assume alpha = 1.

Reference no: EM13274332

Questions Cloud

State what is the percent yield of a reaction : What is the percent yield of a reaction in which 258 g phosphorus trichloride reacts with excess water to form 120. g HCl and aqueous phosphorous acid (H3PO3)
What is the capacitance that should be placed in parallel : A network has an input impedance of 120+100j Ω what is the capacitance that should be placed in parallel with the network to provide an input impadance with: a) Zero Reactance at w=1000 rad/s b) Zero Reactance at w=2000 rad/s
Determine the frequency of circling : An electron with kinetic energy 3.90 keV circles in a plane perpendicular to a uniform magnetic field. The orbit radius is 12.0 cm. find the frequency of circling
Define what is the concentration of the stock solution : A standard solution was made when 1.276g of pure copper wire (MM= 63.546g/mol) was weighed, dissolved in concentrated HNO3, and diluted to 1.00x102mL. What is the concentration of the stock solution
What is the resulting overall voltage gain of cb amplifier : A CB amplifier is operating with R load = 10 kiloohms, Rc = 10 kiloohms, and R signal = 100 ohms. At what current Ic should the transistor be biased for the input resistance Rin to equal that of the signal source
Explain neutralize the acid and convert : If, in practice, 5.0 mL of 16.0 M nitric acid were added to effect the dissolution of the copper, what would be the minimum volume of 4.00 M NaOH required to neutralize the remaining acid and convert all of the Cu2+(aq) to Cu(OH)2(s)
Find his resultant displacement from camp : hiker starts at his camp and moves the following distances while exploring his surroundings: 75.0 m north, Find his resultant displacement from camp
Find the corresponding range of rout and g : An emitter follower is operating at a collector bias current of 0.25 mA and is used to connect a 10 kiloohm source to a 1 kiloohm load. If the nominal value of beta is 100, what output resistance Rout and overall voltage gain G result
Determine which waveform in each pair is lagging : Determine which waveform in each pair is lagging: a) 6 cos(100πt-1000) and -6 sin (2π60t+1300)b) cos(10t-1000) and - cos(t-1000) c) cos (50πt - 1000) + cos (50πt - 200) and 9 cos (100πt - 200)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the minimal sum and distinguished 1-cell using k-map

Find the minimal sum and distinguished 1-cell using Karnaugh Maps for the following functions, also state essential prime implicants (if any) and which are non-essential prime implicants (if any) a. F = fA,B,C,D (2,,4,6,7,12,13,14,15)

  What is the minimum sampling frequency to sample the signal

A bandlimited signal with maximum frequency of 3.3 kHz, what is the minimum sampling frequency to sample this signal If a sinusoidal signal of 7 kHz is sampled by this sampling frequency, what is the frequency of the alias.

  Derive the dynamic model and average value circuit

Derive the dynamic model and average value circuit of a buck converter assuming the ESRs of the inductor and capacitor are not equal to zero.

  What electrical parameter does an ohmmeter measure

WHAT ELECTRICAL PARAMETER DOES AN OHMMETER MEASURE AND WHAT ARE ITS UNITS. SHOW BOTH NAME AND SYMBOL FOR THE PARAMETER AND ITS UNITS.

  Calculate the value of the resistance that should be added

A 15 hp, 209V,three-phase,six pole, Y-connected induction motor has the following parameter values per phase: R1= 0.128 ohm, R'2=0.0935 ohm Xeq- X1 + X'2 = 0.49 ohm. The motor slip at full load is 3%, and the efficiency id 90%.

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Determine the steady state drop in area frequency

An interconnect 60-Hz power system consist of one area with three turbine genrator units rated 1000,750,500 MVA respectively. The regulation constant of each unit is same R=0.05 per unit based on its own rating.

  Find range of values of fc can be used to transmit signal

The signal x(t) = 20*sinc2(400t) is input to a ring moodulator. Sketch the spectrum of vout and find the range of values of fc that can be used to transmit this signal.

  Describe the how the hall effect it is used to measure

Describe the how the Hall Effect it is used to measure whether a semiconductor material is n-type or p-type. Sketch a diagram and show the critical measurements.

  Determine the transfer function for band pass filter

Determine the transfer function for a second order band pass filter with specifications. Chebyschev type with 1 db ripple in the pass band Lower cutoff frequency = 100 radians/sec Upper cutoff frequency = 169 radians/sec Pass band gain = 1

  What is the capacitance of the capacitor in microfarads

A 40 kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 2.5 mV. When this voltage is applied across the terminals of a capacitor, the resulting steady-state current has a maximum amplitude of 125.67

  Determine the poles and zeros of the filter

Design a filter for a biomedical instrument to eliminate DC (f = 0), 500 Hz tone, and its corresponding harmonics. The system sampling rate is 2,000 Hz. Place all the required poles at the origin to obtain a FIR filter.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd