User Account

All Pages

What is the required resistor value of rc high-pass filter

Assignment Help Electrical Engineering
Reference no: EM13269174

A first-order RC high-pass filter has a cutoff frequency of fc = 2400 Hz and the capacitor value of C = 47 nF. What is the required resistor value?

Reference no: EM13269174

Questions Cloud

State two miscible liquids with different boiling points : During the distillation of a mixture of two miscible liquids with very different boiling points, the temperature rises to a constant reading and then drops off before returning to a higher reading. Explain the likely cause of this fluctuation in t..
What is the maximum initial cost the company : What is the maximum initial cost the company would be willing to pay for the project?
How much must you accumulate by the time : What equal, annual amount must you save at the end of each of the next 15 years to achieve your objective, assuming you currently have $10,000 available to meet your goal?
What is the temperature of the cold reservoir : An ideal engine has an efficiency of 0.605 and uses gas from a hot reservoir at a temperature of 502 K. What is the temperature of the cold reservoir
What is the required resistor value of rc high-pass filter : A first-order RC high-pass filter has a cutoff frequency of fc = 2400 Hz and the capacitor value of C = 47 nF. What is the required resistor value
Find the maximum magnitude of the acceleration : A 0.70-kg mass attached to a vertical spring of force constant 140N/m oscillates with a maximum speed of 0.40m/s, Find the maximum magnitude of the acceleration
What is the standard deviation of these returns : A stock is expected to earn 43 percent in a boom economy and 21 percent in a normal economy. There is a 49 percent chance the economy will boom and a 51.0 percent chance the economy will be normal. What is the standard deviation of these returns?
Compute the ph of propanoic acid after hcl is added solution : Calculate the pH of 0.1000 M Propanoic acid (HC3h502, Ka=1.3x10^-5) after 0.020 moles of HCl is added to 1.00 L solution. Calculate the pH of 0.1000 M Sodium Propanoate NaC3H5O2 (HC3H502, Ka=1.3x10^-5) after 0.020 moles of HCl is added to 1.00 L so..
What is the magnitude of the total circuit impedance : If an input signal with v(t) = 10 sin ( 2pi f 1592 t + 0º ) is applied to a series RL circuit with R = 1000-ohm and L = 0.1 H, what is the magnitude of the total circuit impedance

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Select right components for integrator and differentiator

How would you select the right components for the integrator and differentiator. What do you think would be the limiting factor in the component parameters, and in the input signal frequency

  Find what is direction of robot arm in closed loop system

The controlled variable in a closed-loop system is the direction of a robot arm. Initially, it is at 50o; then it is commanded to go to 15o. When the error is 10o for the first time, what is direction of the robot arm

  Find the input power-pin to calculate the snr

an amplifier with a 1 MHz bandwidth and a 20 micro-V input signal. The input noise = 1 micro-V, output signal = 6.0 mV, and output noise = 1 mV. Find (a) SNR at the input Pin = Pn(in)= K(T)BW= 1.38*10-23(290)1MHz= 4*10-15W

  Determine the conductor size for each motor tap

Determine the conductor size for each motor tap, the motor controller size, overload rating, motor and controller disconnect rating, time-delay fuse rating, and motor branch circuit conductor size.

  Explain plotting continuous time signal

Plotting Continuous time signal, Consider the following continuous signal: x(t) = 10e^-3t u(t) Using Matlab, plot the continuous-time signal over the range -1=

  Design an 8051 microprocessor system that has total space

The EPROM should be mapped in a single block starting at address 0000 hex and the RAM should be mapped in a single block starting at address 8000 hex. 8051: Hardvard architecture with separate control busses for code and data memory.

  Why is the ability unique to sychronous alternators

a) the synchronous generator has a unique ability whihc places it at the top of the heap of all machines that might be used for generation of electric power. This unique capability is what allows the business of electric dispatch to even occur.

  Reduce the equation to the slope-intercept

Reduce the equation to the slope-intercept form and give the slope and the y-intercept.

  Determine what is the mass of the meter stick

A meter stick is found to balance at the 49.7-cm mark when placed on a fulcrum. When a 60.0-gram mass is attached at the 27.0-cm mark, the fulcrum must be moved to the 39.2-cm mark for balance.

  What is hall electric field is measured in the y direction

Show that the Hall coefficient for a p-type semiconductor is R_H=1/pe where p is the hole concentration and e is the electron charge. Assume the current is along the +x direction, the magnetic field is along the +z direction, and the Hall electric..

  Calculate the voltage regulation of the transformer

The following test data were taken on a 110-KVA, 4400/440- volt, 60-Hz transformer: Short Circuit Test: P= 2000w, I = 200 amp, V = 18v Open Circuit Test: P=1200w, I= 2 amp, V = 4400v Calculate the voltage regulation of this transformer when it suppli..

  Create a flowchart and pseudo-code for generating

Create a flowchart and pseudo-code for generating a report that prints all of the movies, with all movies made by the same director on one page, as well as the number of movies by each director.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd