What is the pressure at the crown in kn

Assignment Help Civil Engineering

Reference no: EM13556954

A 60 m long siphon spillway discharges water at .32 m^3/s. The siphon crown is 1.2m above the water surface elevation of the reservoir and a length 10m away from the siphon entrance. If the siphon diameter is 30 cm, if the friction factor is .02, and the headless coefficient are .2 (inlet) and 1 (exit), what is the elevation difference between the siphon crown and the downstream pool? What is the pressure at the crown in kn/m^2?

Reference no: EM13556954

Questions Cloud

What is the probability that the amound absorbed at the end : During the two hour period, an intermediate reading reveals that the percent absorbed is 3 percent. What is the probability that the amound absorbed at the end of the two hour period will be greater than 5 percent?

What is the magnification of the instrument : A compound microscope has objective and eyepiece focal lengths of 6.5mm and 2.2cm , respectively. what is the magnification of the instrument

How many weeks must pass before the likelihood of the lake : A lake has a water level which is used to determine if watering restrictions need to be implemented for the neighboring city. Water levels are measured on a weekly basis, and restrictions are placed if the lake level drops below 1060 ft. Weekly water..

Determine what mass of ethanol diffuses through the cylinder : The diffusion constant for the alcohol ethanol in water is 1.24 10-9 m2/s. A cylinder has a cross-sectional area of 3.95 cm2 and a length of 1.84 cm. what mass of ethanol diffuses through the cylinder

What is the pressure at the crown in kn : A 60 m long siphon spillway discharges water at .32 m^3/s. The siphon crown is 1.2m above the water surface elevation of the reservoir and a length 10m away

What would the spindle diameter need to be in order : The crane hoists a uniformly distributed load C. the two identical motors at A an power through gearboxes operating at maximum output speed of 100 rpm.the load is lifted by winding cable onto spindles attached to the output shaft of each gear box. Th..

Evaluate what was the initial speed of the rock : a rock is thrown downward into a well that is 8.85 m deep. if the splash is heard 1.20 seconds later, what was the initial speed of the rock

What is the cross product of these two vectors : Given two vectors,A= (4i + 1j) and B = (-1i + 4j) (3) What is the sum of these two vectors, What is the cross product of these two vectors

What is the maximum accelaration from rest : A newly designed car has a 9.2 ft wheelbase, is rear wheel drive, and has a center of gravity 18 inches above the the road and 4.3 ft behind the front axle. the car weighs 2450 lb

User Account

All Pages