What is the power received by the radio telescope

Assignment Help Electrical Engineering
Reference no: EM13280404

Frank D. Drake, an investigator in the SETI (Search for Extra-Terrestrial Intelligence) program, once said that the large radio telescope in Arecibo, Puerto Rico, can detect a signal which lays down only a picowatt of power over entire surface of the Earth. What is the power received by the radio telescope if the diameter of the antenna is 300 m? What would be the power of the source at the center of our galaxy which could provide such a signal? The center of galaxy is 22000 light years away. Assume that source is radiating uniformly in all directions and that the Earth is a disk with the radius of 6378 km.

Reference no: EM13280404

Questions Cloud

Compare the cost of the resulting sum-of-product excitation : redesign the 1s-counting machine, assigning the states in the binary counting order (S0-S3=00,01,10,11). Compare the cost of the resulting sum-of-product excitation equations with the ones derived in the text.
Design a low cost white led based emergency light : Design a low cost white LED based emergency light that turns on when the main supply fails, and turns off when the main supply resumes. The circuit must have its own battery charger. When the battery is fully charged, charging stops automatically.
Calculate the value of a bond : Calculate the value of a bond that matures in 12 years and has a $1,000 par value. The annual coupon interest rate is 13% and the yield to maturity on a comparable risk bond is 11%. (show work as well as answer)
Explain what is the vapor pressure of the solution at 20 °c : A solution is made by mixing 46.0 mL of ethanol, C2H6O, and 54.0 mL of water. Assuming ideal behavior, what is the vapor pressure of the solution at 20 °C
What is the power received by the radio telescope : Frank D. Drake, an investigator in the SETI (Search for Extra-Terrestrial Intelligence) program, once said that the large radio telescope in Arecibo, Puerto Rico, can detect a signal which lays down only a picowatt of power over entire surface of ..
Find impulse does the clay exert on the block : A 50g ball of clay is thrown horizontally at 40m/s toward a 1.5kg block sitting at rest on a frictionless hi surface. The clayts and sticks to the block. What impulse does the clay exert on the block
Explain what is the average cell surface area : Estimate the average area of a cell in square micrometers, and the diameter of a single cell in micrometers, using the data below. Assume the cells are roughly spherical. What is the average cell surface area
How would the required return for equity holders change : If a company increases the ammount of debt financing in the company's capital structure, how would the required return for equity holders change? Expain why in more than 2 sentences.
What speed ship will attain in 1day assuming that reflection : A 10 kW laser beam pointing at the ship is turned on at t=0. What speed the ship will attain in 1 day assuming that the surface of the ship is perfectly reflective and perpendicular tot the beam.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the feedback factor if a manufacturing error results

A negative feedback amplifier has a close-loop gain Af=100 and an open-loop gain A=105. What is the feedback factor If a manufacturing error results in a reduction of A to 103, what close-loop gain results

  Find what is the source resistance of the sensor

A temperature sensor is specified to provide 2 mV/°C. When connected to a load resistance of 10 k ohm, the output voltage was measured to change by 10 mV, corresponding to a change in temperature of 10°C.

  Explain the operation of sequential logic devices

Explain the operation of sequential logic devices and evaluate the output waveform in relation to the clock for QA, QB and QC in the subsequent circuit and show the binary sequence represented by these waveforms

  How is the tcnt timer used to generate an interrupt

1.The S12G128 CPU board has one IRQ pin. You have four devices that will request interrupt service. How do you determine which device(s) need service 3.A communications channel has a bandwidth of 2,000 Hz and a signal-to-noise ratio (SNR) of 40 dB.

  Determine what is the range of decimal numbers

What is the range of decimal numbers that can be represented in 16-bit register assuming the following (a) Numbers are unsigned (b) Numbers are signed (in signed-magnitude representation)

  What will the secondary voltage be

If a transformer has a turns ratio of 1:5 and a primary voltage of 20 V AC, what will the secondary voltage be?

  Find at what overdrive voltage is the mosfet operating

What is the maximum output resistance that the source follower must have if the output voltage is to remain within ±20% of nominal value. If the MOSFET has kn = 16 mA/V2, at what current ID must it be biased. At what overdrive voltage is the MOSFE..

  Find magnetic field intensity at origin use magnetic field

A constant current I is flowing in a semi infinite loop. Find magnetic field intensity at the origin: H(0,0,0). Use magnetic field intenisty for a piece of wire.

  What would be expected ohmmeter reading of potentiometer

In the Wheatstone bridge resistance measurement experiment, if Rx = 4 k-ohm, what would be the expected ohmmeter reading of the potentiometer's resistance

  How parameters must be constrained to make system constant

In the question below only focus on the parameter or parameters that are relevant to the particular property you are being asked about in the particular question. If you need to constrain a parameter to satisfy the stated criterion.

  Find the complex power of the other load

two loads connected in parallel are supplied from a single phase 240v rms source. the two loads draw a total real power of 400 kw at a power factor of 0.8 lagging. one of the loads draws 120 kw at a power factor of 0.96 leading.

  What is the ratio of the torque produced by the force

The steering wheel of a car has a radius of 0.11 m, while the steering wheel of a truck has a radius of 0.28 m. The same force is applied in the same direction to each. What is the ratio of the torque produced by this force

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd