What is the power dissipation in inverter at clock frequency

Assignment Help Electrical Engineering
Reference no: EM13271323

If a clock signal is passed through a CMOS inverter to drive a capacitive load of 1pF, what is the power dissipation in this inverter if the clock frequency is 500MHz? Assume the supply voltage is 3V and the process is characterized by a reference inverter with tREF=20ps, CREF=4fF, RPDREF=2.5K

Reference no: EM13271323

Questions Cloud

Business intelligence and data warehouses : Business Intelligence and Data Warehouses
Explain the concentrations of carbonate and hydroxide : Calculate the pH of a water at 25oC that contains 3.69 mg/L of carbonic acid. You may assume that the concentrations of carbonate and hydroxide are negligible and that there are no other ions present in solution.
Find the velocity of the regulation hockey puck : A regulation hockey puck of mass 675 g is sliding right at 1.66 m/s. What is the velocity (including magnitude and direction left/right) of the regulation hockey puck after the collision
Explain the molar heat capacities for liquid gaseous water : The enthalpy of vaporization of water at 373 K and 1 bar is 40.7 kJ/mol and the molar heat capacities are 75.3 J/(mol K) for liquid and 33.6 J/(mol K) for gaseous water. Find the enthalpy of vaporization of water at 273 K and 1 bar.
What is the power dissipation in inverter at clock frequency : what is the power dissipation in this inverter if the clock frequency is 500MHz. Assume the supply voltage is 3V and the process is characterized by a reference inverter with tREF=20ps, CREF=4fF, RPDREF=2.5K
How fast is she going : A runner approaching the start/finish line hears the bell signaling one lap to go. The bell emits a 352 Hz tone, How fast is she going
Compare the input sequences on the two inputs : A sequential circuit hast two inputs (w1 and w2) and one output (z). Its function is to compare the input sequences on the two inputs. If w1 = w2 during any four consecutive clock cycles, the circuit produces a z=1
Find the velocity of the plane relative to the earth : A plane is headed due west with an air speed of 224 m/s. Find the velocity of the plane relative to the earth
Calculate minimum power required to operate the heat pump : Under steady operating conditions, cold water at 15 oC and 200 kPa enters the water heater with a flow rate of 54 kg/min and leaves the water heater at 80 oC and 200 kPa. During its operation the water heater loses heat to its surroundings at the ..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How much energy is released by the nuclear reactions

A summary of the nuclear reactions that power our sun can be written as 4p 4He + 2e-, with masses of 938.272 MeV/c2 for p, 3727.38 MeV/c2 for helium, and 0.511 MeV/c2 for electrons.

  Find the rms input noise power level

When the amplifier is operating with a bandwidth first of 10MHz, find? 1) The RMS input noise power level? 2) The audio output power level? 3) The RMS output noise power level?

  What does happen when the restriction is violated

What is the function of the enable control input of a tri-state buffer. If the output of two or more tri-state buffers is connected to each other, what is the restriction on enable control input lines.

  Define whether given function had finite or infinite energy

How would you determine whether a given function, f(t), had finite or infinite energy. Give an example of a function with finite energy and one with infinite energy.

  What is the velocity at the end of the pipe

Seawater with a specific weight of 64.0 lbs/ft^3 is at a level of 4 feet above the centerline of the exit pipe. The tank is closed at the top and there is a pressure of 1 psig above the seawater. What is the velocity at the end of the pipe

  Explain looking at feedback and some opamp problems

Looking at feedback and some Opamp problems, If the unity gain frequency is 5 MHz and the midband open-loop voltage gain is 200,000, what is the cutoff frequency?

  Find and plot the system zero-state response to input signal

A DT system has the unit pulse response h[nT] = (0.4)^-|n|. Find and plot the system zero-state response to the input signal x[nT] = u[(n+2)T] + u[(u-2)T]

  Find all the values of the circuit elements and dc gain

Design a circuit which realizes this filter using Sallen-Key configuration.  Find all the values of the circuit elements and determine the DC gain. For sake of easy availability of parts to build the circuit, chose the capacitors needed to be 0.01..

  Calculate closest integer cubic root of 16-bit signed number

Write a 68000 assembly program to calculate the closest integer cubic root of a 16-bit signed number, saved in memory at a location labeled "NMBR". Obligatory Note: Use the subroutine concept in your solution

  What is the power supplied by the current source

e) What is the value of C such that the energy stored in the capacitor equals the energy stored in the inductor f) How much energy is stored in the 3.9?F capacitor Use the formula for the energy. g) What is the power dissipated in the resistors

  Find the electric field at the corner of square of siderant

Find the electric field at the corner of the square of sidérant 30 cm at the corner P due to the charge at the other three q1=4.0uc,q2=7.0uc and q3= 3.0uc (b) compute the electric potential at the point p.

  Determine the probability that each of the pick is a nokia

A family selects two phones from a box containing cellphones: four are Nokia, marked N1, N2, N3, and N4. The other three are Samsung, marked S1, S2, and S3. Two phones are picked randomly in succession without replacement.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd