Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A light bulb has a filament of metal that has an emissivity of 0.3 and a surface area of 5.0 x 10^-5 m^2.
It is heated to 2500 degrees Celsius in an environment with a temperature of 25 degrees Celsius.
What is the power dissipated through radiation by the filament?
Using the exponential formula for a charging circuit and assuming an initial voltage of zero volts across the capacitor, calculate the voltage across the capacitor at a. t = 1.5 seconds b. t = 2.5 seconds
An amplifier with 40 dB of small-signal open-circuit voltagegain, an input resistance of 1M-ohm ,and an output resistance10-ohm drives a load of 100-ohm .What voltage and power gains(expressed in dB) would you expect with the load connected
H(s) = ( 100 (s + 20) (s + 50) ) divided by ( ( s +8 ) ( s + 300 ) ( s + 5000 ) ) Determine the Bode magnitude and phase responses forH(s). Label all slopes and dB values.
Suppose we transmitted 5 cos wct for logic one and 15 cos wct for logic zero. Find the maximum signal energy. Design a demodulator and show the detection criterion for the output of the demodulator. Finally, find the bit error-rate.
Dynamic RAM that must be given a refresh cycle 64 times per ms. Each refresh operation requires 150 ns. memory cycle requires 250 ns.
inkjet printer power and rating probleman a4 inkjet printer uses ink cartridges with a mass of 250g supported by a
64-bit ripple-carry adder and a 64-bit carrylookahead adder with 4-bit blocks. Use only two-input gates. Each two-input gate is 15μm2, has a 50 ps delay, and has 20 pF of total gate capacitance. You may assume that the static power is negligible.
Construct an inverting Dc integrator circuit using a jumperwire to act as the switch across the feedback capacitor. Notice that the input voltage is 0 V, so the output voltage shouldnot change, even after the switch is opened.
Delta load Assume that the load is delta connected. Each phase has a series RL load with R = 5 ohms and L = 20 mH. Plot the phase to phase voltage (Vab) versus time for one cycle. Hint: Vab = Va - Vb
A LSTTL gate has an IOL = 8 mA. How many standard TTL gates can this gate drive. The standard TTL gate has IIL = -1.6 mA
Why is Continuous On-line Monitoring of Partial Discharge in the Switchgear Necessary?
A linear circuit has a capacitance of 1.0 mF and an inductor of 1.0 µH. If the frequency response of the voltage gain should stay the same and the capacitor is scaled to 70 µF, what should the value of the inductor be
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd