What is the power advantage of this autotransformer system

Assignment Help Electrical Engineering
Reference no: EM131203183

An autotransformer is used to connect a 12.6-kV distribution line to a 13.8-kV distribution line. It must be capable of handling 2000 kVA. There are three phases, connected Y-Y with their neutrals solidly grounded.

(a) What must the NC / NSE turns ratio be to accomplish this connection?

(b) How much apparent power must the windings of each autotransformer handle?

(c) What is the power advantage of this autotransformer system?

(d) If one of the autotransformers were reconnected as an ordinary transformer, what would its ratings be?

Reference no: EM131203183

Questions Cloud

Determine the losses in the transformer : Sketch the equivalent circuit referred to the low-voltage side of one phase of this transformer. Calculate all the transformer impedances referred to the low-voltage side.
What is resistance at given freezing and boiling temperature : The resistance of a copper wire is 0.002 Ω at room temperature (68°F). What is its resistance at 32°F (freezing) and 212°F (boiling)?
Find per-unit equivalent circuit of this transformer bank : Find the voltage regulation of this transformer bank at the rated load and 0.90 PF lagging.
What would be a good plan to recommend to greg parents : Compare the dangers of exposure to videogame violence with other forms of violence. What are similarities and differences between videogame violence exposure and the other type of violence you chose to compare?
What is the power advantage of this autotransformer system : If one of the autotransformers were reconnected as an ordinary transformer, what would its ratings be?
Explain what bounded rationality is : Explain what Bounded Rationality is. Then discuss how this concept can affect the decision situation in SLP 1 - Also discuss how this concept can affect the data analysis in Case 1.
Find the temperature of a copper wire : a. The resistance of a copper wire is 0.92 Ω at 4°C. At what temperature (°C) will it be 1.06 Ω? - At what temperature will it be 0.15 Ω?
Identify the intent of the program : Identify the intent of the program as well as its requirements and any evaluations completed - Write a 1-2 page paper in APA format, summarizing its impact or potential impact and your recommendations for the future.
Examine the key elements of virtue and character : Determine a philosophy and approach for balancing the use of reward and punishment in criminal justice. Provide one to two (1-2) examples illustrating how you will use this philosophy in your own career.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate amount of work done if all losses are neglected

A container with a plunger compresses one pound mole of an ideal gas from 1 atmospheres pressure to 10 atmospheres. Calculate the amount of work done if the process is considered to be polytropic.

  Create a schematic for a bjt amplifier using amplifier

Create a schematic for a BJT amplifier using the 2n3904 amplifier. Build an amplifier from 100 Hz to 20 khZ witha gain of at least 100. Input should be 10 mV p-p

  Find the specific heat of the unknown object

It is necessary to determine the specific heat of an unknown object. The mass of the object is 170.0 g. It is determined experimentally that it takes 20.0 J to raise the temperature 10.0° C. Find the specific heat of the object.

  Describe bandpass filters with any center frequency

an Armstrong indirect FM modulator to generate an FM carrier with a carrier frequency of 96 MHz and deviation of f=20 KHz. A narrowband FM generator with Fc=200 KHz and adjustable deviation f in range of 9 to 10 Hz is available.

  How many standard ttl gates can this gate drive

A LSTTL gate has an IOL = 8 mA. How many standard TTL gates can this gate drive. The standard TTL gate has IIL = -1.6 mA

  What is smallest frequency that can be used by signals

What is the smallest frequency that can be used to sample each of the following continuous-time signals such that the signal can be recovered from the discrete samples (a) \(x(t)=1+cos(2000\pi t)+cos(4000\pi t)\)

  Calculate the thevenin equivalent impedance zth

1) Calculate the open circuit voltage VOC (ZL removed) (magnitude and phase angle) 2) Calculate the Thevenin Equivalent impedance ZTH for this circuit (magnitude and phase angle)

  Convert both voltage sources to current sources

a. Using the superposition theorem, determine the current through the 12 ohms resistor. b. Convert both voltage sources to current sources and recalculate the current to the 12 ohms. c. How do the results of parts (a) and (b) compare

  Find the active and the reactive power of the load

A three-phase Y- connected load is rated at 240 volts with power factor .95 (lagging), if the total apparent power is 240 KVA, compute: a. the phase currents (in polar form). There are 3 values. b. the active and the reactive power of the load at it..

  Plot the input and output constant-gain circles

Design an amplifier for a power gain of 15dB at 3 GHz if 1. Plot the input and output constant-Gain circles. 2. Find the input and output matching networks. use L C components.

  What is the maximum power dissipated in the load

What is the maximum power dissipated in the load when the Thévenin voltage is 17 V cos(37 rad/s t + 24°), the Thévenin impedance is 127 -j 182-ohm and the load impedance is 127 + j 182-ohm

  Determine the autocorrelation rxx of the signal x

An audio signal s(t) generated by a loudspeaker is reflectedat two different walls with reflection coefficientsr1 and r2. The signal x(t)recorded by a microphone close to the loudspeaker, after sampling,is: x(n) = s(n) + r1s(n-k1) +r2s(n-k2)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd