What is the percentage regulation of the supply

Assignment Help Electrical Engineering
Reference no: EM13766841

If a power supply has a no-load voltage output of 100V and a 96V output under full load, what is the percentage regulation of the supply?

 

 

Reference no: EM13766841

Questions Cloud

What is the range of error for this reading : 2)   If a 0-20V voltmeter has an accuracy of 1 percent full scale, between what limits may the actual voltage lie when the meter indicated 12V? What is the range of error for this reading?
What is level of current liabilities : Acme incorporated has a debt ratio of .42 non correct liabilities of 20,000 and total assets of 70,000. What is acme's level of current liabilities?
Write a literary analysis of the island of doctor moreau : Write a Literary analysis of The Island of Doctor Moreau.
Withdraws the entire amount and puts it in a mutual fund : At the end of each quarter, a 30-year-old woman puts $2000 in a retirement account that pays 6% interest compounded quarterly. When she reaches 55, she withdraws the entire amount and puts it in a mutual fund that pays 8.7% interest compounded monthl..
What is the percentage regulation of the supply : If a power supply has a no-load voltage output of 100V and a 96V output under full load, what is the percentage regulation of the supply?
Injecting huge liquidity and there is no fear of inflation : We have the Fitzpatrick bond which has a convexity of 30, duration of 4, a ytm of 12% and a maturity of 25 years. The central bank is injecting huge liquidity, and there is no fear of inflation. If the yields alter by 100 basis points, what would the..
What is the terminal voltage : An automobile battery has an open-circuit voltage of 13.6V and a total internal resistance of 0.012 ohms. What is the terminal voltage (the voltage across the plus and minus terminals) of the battery when it is delivering 250A to the starter motor?
What is the power output : A computer power supply delivers 6A at 12V, 10A at -5V, and 12A at 5V. What is the power output of this supply?
The temperature coefficient of nichrome : If a resistor wound of nichrome wire has a resistance of 25 ohms at 42 degC, find the resistance of the resistor at 210 degC. The temperature coefficient of nichrome is +0.0004.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate hall voltage across the wire

An Aluminum wire with a square cross section 2mm on a side is carrying a current of 1.5amps. Aluminum has a resistivity of 2.69*10^-6 ohm-cm and an atomic volume of 10cc/mol. Assuming aluminum has three free electrons per atom

  Determine the slip of mechanical rotational losses

An induction motor has an output or shaft power of 30 kW at 86% efficiency. For this operatingcondition, stator copper loss = rotor copper loss = core loss = mechanical rotational losses. Determine the slip.

  A woman at point a on the shore of a circular lake with

a woman at point a on the shore of a circular lake with radius 2 mi wants to arrive at the point c diametrically

  Determine what is the complex frequency of the signal

Your new assistant has measured the signal coming from a piece of test equipment, writing v(t) = Vxe(-2+j60)t, where Vx = 8-100V. (a) There is a missing term, what is it and how can you tell it's missing (b) What is the complex frequency of the si..

  Determine what will be the output at the maximum load

If it is instrumented with four active strain gages on awheatstone bridge, two axial and two transverse as shown, with S,i.e. strain gage factor of 2.1, initial resistance of strain gagesR = 350 Ω, and the power supply is 10V, what will be theoutp..

  Calculate the amout of mmf generated by a coil

calculate the amout of mmf generated by a coil of wire having 1300 turns and carrying milliamperes of current?

  What is the mass percentage of each element in acetic acid

acetic acid contains only C,Hand O.An 8.48mg sample of acetic acid is completely burned. it gives 12.42mg of carbone dioxide and 5.08 mg of water. what is the mass percentage of each element in acetic acid

  Assume both antennas are ideal.

Assume both antennas are ideal.

  What is the magnetic field at the center of the rectangle

A 1cmx2cm rectangular wire loop carries a current of 2A. What is the magnetic field at the center of the rectangle

  Determine the average diode current of full-wave rectifier

A full-wave rectifier is to be designed using the bridge circuit configuration. The peak output voltage is to be 9 V, the nominal load current is to be 100 mA, and the ripple voltage is to be limitedto Vr= 0.2 V.Assume Vγ= 0.8 V and let vI= 120√2s..

  What is the depth of modulation of an am waveform

a 10 khz sinsudal signal is used to amplitude modulate a sinsoidal carrier frequency of 50 khz the number of frequency components that would be included in the resulting DSP AM waveform would be

  Determine the peak output voltage for bridge rectifier

determine the peak output voltage for bridge rectifier assuming the particle model what PIV rating is required for the diode the transformer is specified to have a 12Vrms secondary voltage for the standard 110 vacross the primary

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd