What is the percentage error in the bulk unit weight

Assignment Help Civil Engineering
Reference no: EM13555152

The void ratio of the soil is 1.2. Determine the bulk and effective unit weights for the following degrees of saturation a) 75% b) 95% c) 100%.

What is the percentage error in the bulk unit weight if the soil is the percentage error in the bulk unit weight if the soil is 95% saturated but assumed to be 100% saturated?

Reference no: EM13555152

Questions Cloud

Determine the liquid limit : The following data were recorded from a liquid limit test on a clay using the Casagrande cup device.
Is this soil a food foundation material : The results of a particle size analysis of a soil are given in the following table. No atterberg limit test were conducted.
Determine the liquid limit of this clay : The following results were obtained from a liquid limit test on a clay using the Casagrande cup device.
Determine lengths l1 and l2 so the two materials elongate : A solid cylinder of 50 mm diameter and 900 mm length is subjected to a tensile force of 120kN. One part f the cylinder L1 long is of steel, the other part
What is the percentage error in the bulk unit weight : What is the percentage error in the bulk unit weight if the soil is the percentage error in the bulk unit weight if the soil is 95% saturated but assumed to be 100% saturated?
What must be the allowable elongation : A cylindrical rod of brass alloy (E = 100 GPa,) having a yield strength of 345 MPa is to be subjected to a load of 7500 N. If the length and diameter of the rod are 338 mm and 7.55 mm respectively, what must be the allowable elongation?
What should be the concentration of pollutant : A lagoon with volume 1,200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L. assuming..
With what velocity will air enter the room under : Laboratories containing dangerous materials are often kept at a pressure slightly less than ambient pressure so that contaminants can be discharged through an exhaust system rather than leaked through cracks and around doors to other parts of the bui..
What concentration of ozone should be injected : Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the probability that the annual runoff from

The total annual runoff from small drainage basin is determined to be approximately normal with a mean of 14.0 in. and a variance of 9.0in^2. Determine the probability that the annual runoff from the basin will be less than 11.0 in. in all three of t..

  How much would the starting salary have been in 1983

Assuming that the CPI (82-84) for March 2013 is 232.773, and your starting salary is $55,000. How much would your starting salary have been in 1983 (assume CPI=100).

  Describe what is the maximum acceptable internal pressure

of 2640 psi with a factor of safety of 2.0 with respect to yielding. the yield stress of the steel is 65,000 psi in tension and 32,000 psi in shear. the diameter of the tank is 7.0 in. the minimum required wall thickness is 0.289 in.

  What is the greatest bending moment and where is it located

A cantilever beam of length 50 ft is embedded in a wall at A and has a free end B. A concentrated load of 100 kips upward is located at x = 25 ft from A. A uniformly distributed load of 20 kips/ft downward extends from 25 to 50 ft.

  How to estimate the value of the fuel that is captured

Assume that the service station must fill refill the tank with 4.00 m^3 of gasoline once a week.Draw a mass balance diagram and estimate the annual loss of gasoline vapor (in kg/y) for the splash fill method

  When would the wells start interfering with each other

one of the wells pumps at a rate of 1240 m3/day. the second well pumps at 850 m3/day.if the aquifer has a transmissivity of 2000 m2/day and a storage coefficient of 4x10^-4, when would the wells start interfering with each other.

  Calculate what is the premanent change in length

A 32mm rebar with a guage length of 200mm was subjected to tension to fracture according to ASTM E-8 method. if the rebar is loaded to 390kn only ad then unloaded, what is the premantnt change in length.

  The break up of a liquid jet into droplets of diameter d

the break up of a liquid jet into droplets of diameter d depends on the jet diameter d the jet velocity v viscosity mu

  Find the component forces that the flange bolts must resist

Water at 20 degrees centrigrade in a 85 degree reducing bendis used in what is otherwise a continuous pipe. The systemoperating is 0.10 cubic meters per seconds

  Determine what is the equation for average vehicle delay

What is the equation for average vehicle delay Is it averge queue over arrivals Average queue over average arrivals

  Find the flow rate if the pump puts 22 hp in to the flow

A 110 f t long, 5 in in diameter (f = 0:033) connects two reservoir whose water surface elevations differ by 12 f t. Compute flow rate in pipe.

  Compute the unit weight and dry unit weight of solids

a moisture content of 10.2 % and a specific gravity of solids of 2.65. Compute the unit weight, dry unit weight, degree of saturation, void ratio and porosity.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd