Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
70-mi, single-circuit, three-phase line composed of Ostrich conductors is arranged in flat horizontal spacing with 15 ft between adjacent conductors. The line delivers a load of 60 MW at 230 kV with 0.8 power-factor lagging
(a) Using a base of 230 kV, 1 00 MVA, determine the series impedance and the shunt admittance of the line in per unit. Assume a wire temperature of 500 C. Note that the base admittance must be the reciprocal of base impedance.
(b) Find the voltage, current, real and reactive power, and the power factor at the sending end in both per unit and absolute units.
(c) What is the percent regulation of the line?
The Dynamics of the system are determined by the second order transfer function of the sensing element , which has a natural frequency of ωn=40 rad/sec and a damping ratio =0.1.
A half-wave rectifier circuit with a 1-k ohm load operates from a 120-V (rms) 60-Hz household supply through a 10-to-1 step-down transformer. It uses a silicon diode that can be modeled to have a 0.7-V drop for any current.
Three capacitors of 5, 10, and 15 microfarads are connected in series. Potential difference across the capacitor network is 25v
(a) Draw the equivalent circuit. (b) Determine the ohmic value of the impedances. (c) Calculate the source current in amperes and in percent if the generator operating voltage is 3.8 kV (line-to-line) and a reactance of X=125% is connected in seri..
Two parallel plates separated by 0.20 m are connected to a 12volt battery. An electron released from rest at a location 0.10 mfrom the negative plate. when the electron arrives at a distance0.050 m from the positive plate
A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.
magnetic field, B, is constant, supplied either by a constant field current or by permanent magnets. The input voltage to the armature of the motor,Vin , connects to a circuit containing the armature impedance, R and L in series, and a dependent v..
The design of a home security system requires the use of sensors, including a sensor to measure carbon dioxide levels. Your search resulted in one sensor that provides an output range of [-2V, 1V].
what the process engineer really wants is to have 95 of the boron just below the oxide. however there is an oxide
A 3 phase line delivers 3600kW at a pf lagging to a load. If the sending end voltage is 33kV, and the resistance and reactance of each conductor is 5.31 O and 5.54O respectively, determine the receiving end voltage.
the output response for a system is given as vot a1 - e-at sinat. is this a proper representation for an output
An npn differential amplifier with I = 0.5 mA, Vcc = VEE = 2.5 V, and Rc = 8 kohm utilizes BJTs with B=100 and VBE=0.7 V at Ic = 1 mA. Assuming that the bias current is obtained by a simple current source
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd