Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
In the differential amplifier shown in the schematic, R1 = R2 = 10 k ohm; R3 = R4 = 100 k ohm. Assume the ECG voltage at V1 = 100 mV, and the ECG voltage at V2 = - 100 mV. There is a power line interference of 200 mV at both input sites. What is the output voltage?
Two resistances R1 and R2 are connected in series. We know that R1=60 ohms and that the voltage across R2 is three times the value of the voltage across R1. Determine the value of R2.
The Signal power to noise power ratio is an important measure of the transmission quality of any channel. If at the receiver there is a 12 dB signal to noise ratio and the received signal power is 50 micro W then calculate the received noise power..
If designing a computer configuration for use as a workstation for one specific application, what aspects of the software need to be considered as part of the design process?
an amplifier with a 1 MHz bandwidth and a 20 micro-V input signal. The input noise = 1 micro-V, output signal = 6.0 mV, and output noise = 1 mV. Find (a) SNR at the input Pin = Pn(in)= K(T)BW= 1.38*10-23(290)1MHz= 4*10-15W
Detailed Explanation to Op-Amp, A certain op-amp has an open-loop voltage gain of 100,000 and a common mode gain of 0.2. Determine the CMRR in dB.
A three phase, 25-hp, 440-V, 60-Hz, 1750 rpm, wound-rotor induction motor has the following equivalent circuit parameters:R1=0.20 ohms, X1=1.0 ohms, R2=0.15 ohms, X2=0.8 ohms, Xm=30 ohms The motor is connected to a three phase, 440-V, 60-Hz supply.
An electron is bound in a one-dimensional infinite potential well with a width of 5Å. (a) Calculate the first three energy levels that the electron may occupy. (b) If the electron drops from the third to the second energy level
If the battery is replaced with a 6 Volt battery it was experimentally determine that the no load speed is reduced to 120 rpm. For this situation, determine a new equation for angular velocity,(in rad/sec) versus Torque (in Nm).
Determine the response of the system when aunit step is applied at input.
The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0 ?, what is the value of the smallest resistor?
An infinite planar sheet of charge, with surface charge density rho_s = 3 µC/m^2, is positioned in the x-y plane. Find the E and D fields above and below the plane, assuming that the relative permittivity of the medium
1. Calculate the total (composite) load power factor, true power, reactive power and apparent power. 2. Also calculate the full-load current and the amount of capacitive KVAR needed to bring the overall power factor to .95 lagging.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd