What is the oil flowrate in stb

Assignment Help Civil Engineering
Reference no: EM13533439

Two wells had been drilled on 40-acre spacing. Well 1 is injectionand Well 2 is producing well. Downhole injection pressure is 8500psi, and bottomhole pressure in producing well is 2400 psi. The estimated permeability found from pressure transient analysis is 20md. In reservoir oil has a viscosity of 2.5 cp. AssumeBo=1.3 RB/STB, cross-sectional area=350 ft2.What is the oil flowrate in STB/day?

Reference no: EM13533439

Questions Cloud

Calculate the pressure at the clay-sand interface for two : Calculate the pressure at the clay-sand interface for two cases:1) clay on top of the sand and 2) clay on the bottom of thevertical sand column.
What is the maximum torque the tube can transmit if the : A thin tube of 1/8 in thickness has a mean diameter of 6 in. What is the maximum torque the tube can transmit if the allowable normalstress in compression is 10 ksi?
Find the rate that the trucks line up : A container ship carries 2000 units. It must be unloaded andre-loaded in a 48 hr turnaround. Two cranes are available. Find the rate that the trucks line up, load and pass under each crane.
Calculate the diameter of this pipe : Using the Hazen-Williams approach (seecoefficient table below), find the headloss of water flowingthrough 1,000-ft of 6-ft diameter concrete pipe at a flow rate (Q)of 80 ft3/sec
What is the oil flowrate in stb : Two wells had been drilled on 40-acre spacing. Well 1 is injectionand Well 2 is producing well. Downhole injection pressure is 8500psi, and bottomhole pressure in producing well is 2400 psi.
How many passengers per day are carried : A bus line 4 miles long runs through an area with 1/6 acre lots,3.5 people per household, average 1 car per household. People willwalk up to 1/6 mile to a bus stop, so stops are located 1/3 mileapart along the route. Say commuters will tolerate 20 mi..
What is the demand for time if left turns are provided : Given the following geometry of an intersection: Four lanes fornorth and southbound traffic; two lanes for east and west boundtraffic. The peak hour volume for
What are the horizontal distances : The slope distances shown were measured with an EDM while the differences in elevation between the ends of each line were determined by leveling. What are the horizontal distances?
Which of these is correct surely not both : Adequately describe the abiotic factors that determinethe types and numbers of species found in yourzone. Examples of factors: temperature, access to sunlightfor photosynthesis, dissolved oxygen content, availability of nutrients such as carbon.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What ph is required to acheive aluminum ion concentration

Aluminum ion (Al3+) is present in an industrial wastewater at 3 mg/L. The treatment facility wants to precipitate out the aluminum until there is only 0.2 mg/L remaining. What pH is required to acheive this aluminum ion concentration

  Calculate the saturated surface-dry bulk specific gravity

the weight of a sample of coarse aggregate was measured under various conditions with the following results: oven-dry weight in air 1076.3 g air-dry weight in air 1083.3 gsaturated-surface-dry weight in air 1089.2 g

  How to determine the amount of heat loss by the system

A closed rigid tank contains 2kg of saturated water vapor initially at temperature of 433K. Heat transfer occurs from the system and the pressure drops to 150kPa. Determine the amount of heat loss by the system.

  What are critical depth and normal depth at given discharge

a low broad crest weir is installed in a wide, rectangular channel to reduce the flow velocity. the channel is 60ft wide, the channel slope is 1 to 2000. Manning's roughness coefficient n=0.014. the discharge per unit channel width is q=60 cfs/ft.

  Determine the maximum fiber stress and the stress in a fiber

A simply supported beam, 2 inches wide by 4 inches high and 12 feetlong is subjected to a concentrated load of 2000 lb at a point 3 ftfrom one of the supports. Determine the maximum fiber stress and the stress in a fiber located 0.5 inches from the t..

  Calculate the equilibrium concentration of dissolved oxygen

Calculate the equilibrium concentration of dissolved oxygen in 15ºC water at 1atm and again at 2,000m elevation.

  What is the probability that the second explosion

Cities cover approximately 0.5% of the Earth's land area, which itself constitutes 29% of the total surface of the planet. What is the probability that the second explosion in part (b) occurs over a city? Assume an equally likely probability of im..

  Determine the sludge age and cell wastage flow rate

Assume: Suspended solids in effluent negligible Wastage is from aeration tank Yield coefficient = 0.4 Bacterial decay rate = 0.04 1/d Effluent BOD5 = 10mg/L F/M = 0.33 mg/mg*d BOD5 after primary settling = 150mg/L MLVSS = 1700mg/L MLSS = 1.4(MLVSS..

  Determine the height a vertical jet of water will rise

Neglecting air resistance, determine the height a vertical jet of water will rise if projected with velocity 58 ft/ s.

  Explain why the architects requires a deflection limitation

The buildings are single story with a rood line 6 feet above the man-door opening is constructed from clay brick that is 12 inches thick and weighs 115 psf. the opening of the man-doors are 3 feet 4 inches wide.

  Determine longitudinal and hoop stresses in the copper pipe

Typical water supply at a faucet in any building is conveyed in copper pipe that is ½" in inside diameter, with a wall thickness of 0.040". If the water pressure is 50 psi and the valve is closed (meaning that water is not flowing)

  Calculate the potential methane production in one year

Solid waste production in the United states was 4.3lbs/person-day. Calculate the potential methane production in one year for a land fill that serves a community of 50,000 people.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd