What is the minimum required kva rating of each transformer

Assignment Help Electrical Engineering
Reference no: EM131203160

Two phases of a 14.4-kV three-phase distribution line serve a remote rural road (the neutral is also available). A farmer along the road has a 480 V feeder supplying 200 kW at 0.85 PF lagging of threephase loads, plus 60 kW at 0.9 PF lagging of single-phase loads. The single-phase loads are distributed evenly among the three phases. Assuming that the open-Y-open-D connection is used to supply power to his farm, find the voltages and currents in each of the two transformers. Also find the real and reactive powers supplied by each transformer. Assume that the transformers are ideal. What is the minimum required kVA rating of each transformer?

Reference no: EM131203160

Questions Cloud

Find the kilovoltampere rating of the transformer : A 10-kVA 480/120-V conventional transformer is to be used to supply power from a 600-V source to a 480-V load. Consider the transformer to be ideal, and assume that all insulation can handle 600 V.
Determine resistance at given temperature : A 22-Ω wire-wound resistor is rated at 200 PPM for a temperature range of -10°C to 75°C. - Determine its resistance at 65°C.
What was the changed : The business changed their policy with regards to the profit mark-upfrom 2018 to 2019 financial year. What was the changed.
Does an acquittal mean that the investigator failed : The news media can affect jury and court decisions by publicizing information about a criminal case before it goes to trial. May police refuse to give information to the press if doing so might jeopardize the case in court? How significantly does ..
What is the minimum required kva rating of each transformer : What is the minimum required kVA rating of each transformer?
Determine the ppm rating of the carbon composition resistor : Determine the PPM rating of the 10-k carbon composition resistor of Figure using the resistance level determined at 90°C.
What is the voltage regulation at those conditions : How does the efficiency of a transformer at rated conditions and 60 Hz compare to the same physical device running a 50 Hz?
Calculation of fbt liability for the year ending : At the end of the year ABC hosted a dinner at a local Thai restaurant for all 20 employees and their partners. The total cost of the dinner was $6,600 including GST. Advise ABC of its FBT consequences arising out of the above information, includin..
Table listing critical temperatures for variety of materials : Find a table listing the critical temperatures for a variety of materials. - List at least five materials with the critical temperatures that are not mentioned in this text.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How can one go about to decode a message from a wav file

how can one go about to decode a message from a wav file. the wave contain a coded message in form numbers. which is represented in the wave in form of tones

  Determine the input so that corresponding output of system

Determine the input x[n] so that the corresponding output of the above system is y[n] = delta[n] - delta[n - 1] Determine the output y[n] when the input is x[n] = cos(0.5pin) for - infinity

  How does the bandwidth of the pci bus compare firewire

The PCI bus found in many desktop computers transmits 64 bits perclock cycle at a 33MHz clock rate. How does the bandwidth of the PCI bus compare to the serial firewire (IEEE 1394) serial busspecification, which is 400Mbits/s

  Find what is the real power applied to the motor in watt

A motor with efficiency of 76% supplies 20 hp to a load. it's power factor is 0.6 (lagging). A voltage of 440 VAC (RMS), 60 hz is applied to the motor. a) what is the real power applied to the motor in Watt

  Find the voltage ratio of a standard buck-boost transformer

A) the required step-up voltage ratio for satisfactory performance. B) the voltage ratio of a standard buck-boost transformer that most closely meets the requirements of the load. C) the voltage at the load with the buck-boost transformer installed.

  Discuss sequential nature of the ripple carry output adder

Discuss the sequential nature of the Ripple Carry Output Adder. Why is it actually a sequential operation What are problems associated with this type of sequential design? How would you alleviate them

  Question 1let us assume there is a two-terminal box there

question 1.let us assume there is a two-terminal box. there are one resistor one capacitor and one inductor inside the

  What is the cost of the operation for 30 days

A 1.8-kW electric heater takes 15 min to boil a quantity of water. If this is done once a day and power costs 10 cents/kWh, what is the cost of its operation for 30 days

  In a metal processing facility the final tailings slurry

in a metal processing facility the final tailings slurry produced by the process is thicken in a caisson and

  Olympic sports has two issues of debt outstanding

Olympic Sports has two issues of debt outstanding. One is a 8% coupon bond with a face value of $21 million, a maturity of 10 years, and a yield to maturity of 9%. The coupons are paid annually.

  Amplify the signal of a microphone with internal resiatance

What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..

  Design a state sequencer using d flip-flops and nand gates

The unused states have to be taken care of in such a way that Even numbered unused states will go to state 7 and Odd numbered states will go to state 3. The combinational logic portion of the circuit should use NAND and NOT gates only.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd