Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A GaAs device is doped with a donor concentration of 3e^15/cm^3 . For the device to operate properly, the intrinsic carrier concentration must remain less than 5% of the total electron concentration. What is the maximum temperature that the device may operate? Note: Although the band gap and the density of states vary with temperature, those variations are much slower compared to the exponential factor e^(-Eg/2KT)
What is the relation between the conductance and the capacitance of two parallel conductors immersed in a lossy dielectric medium that has permittivity and conductivity?
A 150MW alternator generates an open-circut line-t0-line voltage of 12kV at nomial DC excitiation. When the terminals are placed in short-circuit the resulting current per phase is 8000A. a) Calculate the approximate value of the synchronous reacta..
The voltage output from a two active gage of Wheatstone bridge was 3.5 mV. The excitation voltage was 5 V. Nominal resistance of the strain gage was 350 ohms and the gage factor was 2.05. Calculate the force in pounds on the steel rod.
The upper and lower conducting plates of a large parallel-plate capacitor are separated by a distanced and maintained at potentials V0 and 0, respectively. A dielectric slab of dielectric constant 6.0
A three-phase, 400 V system has the following load connected in delta: between the red and yellow lines, a non-reactive resistor of 100; between the yellow and blue lines, a coil having a reactance of 60 and negligible resistance
A 450 kW motor operating 73% Power factor lagging is connected to a 120V(rms), 60Hz line. (a) Sketch and label the power triangle for the motor. (b) Find the rms current into the motor.
determine the following by sloving laplace equations: a) the potential and electric field distribution in the dilectric slab. b) the potential and electric feild distrivution in the air space between the dilectric slab and the upper plate and c) t..
Do either or both of the reasons you gave in part (a) above also apply to a point to point voice link using frequency modulation? c. Which parameter of an FM transmission determines whether it is wideband or narrow band?
Ten multimode glass fibers (n1 = 1.48, n2 = 1.45) are spliced together. Each fiber is 2 km long and has a loss rate 2-dB/km. Each splice adds 1 dB of loss. If the output power of the source is 7 dBm and radiates uniformly in a 60 degree half cone
Each pole of a 100kW, 250v flet-compound generator has a shunt field of 2000 turns and a series field of 7 turns. If the total shunt field resistance is 100 ohms, calculate mmf when the machine operates at rated voltage.
draw out a schematic that implements a 3-bit XOR gate, but consisting of only 2-bit NAND gates. Your schematic should have from 8-10 NAND gates, but NO other logic function such as OR, AND, INV gates can be in your final design.
Rain affects the downlink from the satellite and the overall CNR ratio in the receiver falls by 6.0 dB to 13.0 dB. What is the bit error rate and the time between errors now?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd