What is the maximum number of phases that may be present

Assignment Help Civil Engineering

Reference no: EM13543372

1.For cubic crystals, as values of the planar indices h, k, and l increase, does the distance between adjacent and parallel planes (i.e., the interplanar spacing) increase or decrease? Why?

2.The surface energy of a single crystal depends on crystallographic orientation. Does this surface energy increase or decrease with an increase in planar density? Why?

3.For a ternary system, three components are present; temperature is also a variable. What is the maximum number of phases that may be present for a ternary system, assuming that pressure is held constant?

4.A steel shaft with a diameter of 40mm and length of 1.1m transmits 60hp from an electric motor to a compressor. If the allowable shear stress is 50MPa and the allowable angle of twist is 1.5 degrees, what is the minimum allowable speed of rotation?

Reference no: EM13543372

Questions Cloud

Determine the asd reference and adjusted design values for : Determine the ASD reference and adjusted design values for the following members and loading conditions. All members are Select Structural Southern Pine and are fully braced to prevent lateral torsional buckling. Bending Occurs about the strong axis.

Determine the variation of jet are with elevation : A 60 -m- long steel wire must not strech more than 48mm when the tension in the wire is 6 kn. Knowing that e-200GPa, determine (a)the smallestdiameter which may selected for the wire,(b)the corresponding value of the normal stress.

Historical treatment of children and juvenile justice system : Juvenile Delinquency, and the Interactive Module, "Historical Treatment of Children and Juvenile Justice System. "

How many tons of aggregate will be needed : The allowable stress in a steel shaft with an outside diameter of 1.5in and an inside diameter of 1.1in is 12,000psi. What hp can the shaft deliver at 1750rpm?

What is the maximum number of phases that may be present : For a ternary system, three components are present; temperature is also a variable. What is the maximum number of phases that may be present for a ternary system, assuming that pressure is held constant?

What is the maximum tension in the cable due to the 6-k load : Where should a single 500-lb live load be places on the beam so it causes the largest live moment at D? What is this moment? Assume the support at A is fixed, B is pinned, and C is a Roller

Determine the initial void ratio assume also that settlement : A square building (15 m × 15 m in plan) is to be constructed on a site where the soil profile consists of 3m of clay with an over-consolidation ratio that varies from 5 at the surface to 2 at 3m overlying a 5m thick clay

Calculate and plot the distribution of total and effective : Calculate and plot the distribution of total and effective vertical stresses as well as pore-water pressure with depth from the ground surface up to the bedrock surface.

Determine the minimum time needed for the plate temperature : Consider a 1000-W iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-T6 (density = 2770 kg/m^3 and c(p)=875 J/kg C). The base plate has a surface area of 0.03 m^2. Initially the iron is in thermal equilibruim with the ambient air at 22..

User Account

All Pages