What is the maximum flow for the line

Assignment Help Physics
Reference no: EM131810730

Question: The inside diameter of a hydraulic hose is 0.375 in. It is recommended that the fluid velocity in a supply line not exceed 10 ft/s. What is the maximum flow (GPM) for this line? The response must be typed, single spaced, must be in times new roman font (size 12) and must follow the APA format.

Reference no: EM131810730

Questions Cloud

Excluded from monthly credit card statement : Which of the following can be excluded from a monthly credit card statement?
What pressure is required to accelerate the load : Molten metal is poured from a ladle. Total weight of the full ladle is 18 tons. Just as the pour begins, there is a power failure.
How much is he willing to pay for this money machine : Derek has the opportunity to buy a money machine today. how much is he willing to pay for this money machine?
What pressure drop must the pressure reducing valve maintain : A pressure-reducing valve is set to limit the force exerted by a clamping cylinder. The 1.5-in. bore cylinder must not exert more than 2900 lbf to prevent.
What is the maximum flow for the line : The inside diameter of a hydraulic hose is 0.375 in. It is recommended that the fluid velocity in a supply line not exceed 10 ft/s.
Cost of exchange settlement reserves to commercial banks : Modern central banks, target the cost of exchange settlement reserves to commercial banks and not the quantity of reserves.
How much torque is the motor delivering : A hydraulic motor has a displacement of 0.915 in3/rev, and the pressure drop across the motor is 1740 psi.
Explain the four basic strategies : Could you explain the "Four basic strategies" and provide examples to each term in the model?
Find the flow rate to the cylinder : Sometimes pump flow rate is unknown, and a flowmeter is not available to insert in the line and measure flow. An unloaded cylinder can be used to get.

Reviews

Write a Review

Physics Questions & Answers

  Decide the balls speed

A 0.50 kg ball that is tied to the end of a1.4 m light cord is revolved in a horizontal plane by the cord making a 30° angle, with the vertical. Decide the ball's speed.

  If the freezing compartment is at temperature tl and the

the motor in a refrigerator has power p. if the freezing compartment is at temperature tl and the outside air is at

  Determine what is the value of the resistor

A 120 Volt rms voltage at 1000 Hertz is applied to a 2 mH inductor, a 4.00 μF capacitor and a resistor. determine what is the value of the resistor

  Determine the point on the root locus

The open-loop poles are 1 and 2, whereas the open-loop zeroes are -4 and -2. Sketch the corresponding root locus and also plot using MATLAB.

  A 80-m long wire with a mass of 10 g is under tension a

a 8.0-m long wire with a mass of 10 g is under tension. a transverse wave for which the frequency is 570 hz the

  What is the power delivered by person pulling on the rope

7.3-kg box is being lifted by means of a light rope that is threaded through a single, light, frictionless pulley that is attached to the ceiling. If the box is being lifted at a constant speed of 2.0 m/s, what is the power delivered by the person ..

  Expression for the efficiency of the machine

An amount Q of energy is supplied to a machine. The machine does useful work W and an amount R of energy is wasted. Which one of the following is a correct expression for the efficiency of the machine?

  Obtain the magnitude of angular acceleration of the stick

A stick is resting on a concrete step with 2/5 of its length hanging over the edge. A single ladybug lands on the end of the stick hanging over the edge, and the stick begins to tip. obtain the magnitude of the angular acceleration of the stick

  What is the gauge pressure of the water at the pump

A fountain shoots a jet of water 16 m into the air. The fountain has a round nozzle of diameter 0.627 cm at ground level, What is the gauge pressure of the water at the pump

  What is the induced emf across the inductor

The current increases from 20 mA to 60 mA in a 25 mH inductor over 30 s. What is the induced emf across the inductor

  The reflection of light with wavelengths

A thin film of MgF2 (n = 1.38) coats a piece of glass. Constructive interference is observed for the reflection of light with wavelengths of 400 nm and 600 nm .

  What was the heat input to this engine

A certain heat engine does 8.5 kJ of work and dissipates 8.50 kJ of waste heat in a cyclical process. What was the heat input to this engine

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd