Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
You have a 120 VAC motor pump system. The system will work in a voltage range from 100 to 130 volts. you can count on the minimum voltage from the supplier to be 115 VAC. The wiring will consist of #14 awg which has a resistance of 2.5 ohms/1000 feet. The pump is slightly over 1000 watts.
What is the maximum distance between the pump and the power source?
Compute the amount of time required to deliver 10 frames to the receiver with stop-and-wait flow control. Assume that all frames and ACKs are received correctly.
Explain why a PID controller is not a good idea for this process. Use Matlab to design a PD controller for this process. Repeat the design, but this time use a lead-lag compensation network to cancel the 0.731 time constant and replace it with a 0..
A system has the following input/output relation: y(n) = x(n) + .5 y(n -1). If the input x(n) is the sinusoidal signal shown in problem 1.32(d) (Above), the steady-state output will have the following form: y(n) = A sin(Bn+C). Determine the value ..
where the assigned loop current leaves the voltage source. If current leaves the voltage source at its positive terminal, the voltage would be positive and if it leaves the voltage source at its negative terminal,the voltage would be negative.
Determine the position x and the tension in the cord that is required for equilibrium. The cord passes through the smooth ring at B and has an unstretched length of 6ft and stiffness of k = 50lb/ft.
Find the largest allowable signal swing (peak-to-peak) at the collector to satisfy the two conditions: BJT remains active , and vbe limited to 5 mV . What is the corresponding allowable peak-to-peak input voltage vi
The equivalent circuit parameters are R1=0.48 ohms, X1=0.80 ohms, R2'=0.42 ohms, X2'=0.80 ohms, Xm=30 ohms The motor is operating with slip of 0.04. Find the input current and power factor.
suppose that another FM station is in the vicinity is broadcasting at 98.1 MHz. determine the relative value of the voltage across the resonant circuit at this frequency compared with that at 98 MHz, assume that the current produced by both signal..
Discuss the operation of a JFET, including the pinch off and gate-source cutoff voltage in your explanation. Discuss how you can tell whether an FET is operating in the ohmic region or the active region.
Assume initially that no inputs have been seen and create a special initial state with output 0 to start the Moore machine. Draw a state graph for a Moore machine (minimum number of states is 6).
The solution to Power Factor, Two single-phase loads are connected in parallel across a 415 V, 50 Hz supply. One load is rated 130 kW at a power factor of 0.75
An additional motor load of 100 kW is needed. Find the new kilovoltampere load and power factor of the plant load if the motor to be added is (a) an induction motor with a power factor of 90 percent lagging, and (b) an 80 percent leading power fac..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd