What is the magnitude of the force s if the angle is given

Assignment Help Civil Engineering
Reference no: EM13296294

A pile resists the tension developed by three stay cables for a major tent (Membrane) Structure. Assuming no bending is desired in the pile (no resultant horizontal component), what is the magnitude of the force S if the angle \thetaS = 30 degrees?

If the pile resists with a capacity of 500# per square foot of embedded surface, what is the required penetration h for the pile? Scale :1" = 8k

Reference no: EM13296294

Questions Cloud

How much will sarah payments be : She will make a 25% down payment and her friend will finance the balance with a mortgage calling for annual payments over 20 years at 8.5% per annum interest. How much will Sarah's payments be?
Determine the terminal velocity of the block of cube : A fluid film 0.1 mm thick separates solid and surface. The fluid viscosity is 0.04 N*sec/m^2. Assuming the velocity distribution in the film is linear, find the terminal velocity of the block. The area of the cube in contact with the film is 0.25 ..
Find the work done by this force on the truck : The brakes of a truck cause it to slow down by applying a retarding force of 4520 N to the truck over a distance of 1150 m
Briefly trace its development from a sole proprietorship : Imagine a startup company of your own and briefly trace its development from a sole proprietorship to a major corporation with a focus on how that development would be financed.
What is the magnitude of the force s if the angle is given : A pile resists the tension developed by three stay cables for a major tent (Membrane) Structure. Assuming no bending is desired in the pile (no resultant horizontal component), what is the magnitude of the force S if the angle \thetaS = 30 degrees
Should it be accepted or rejected using a 15% discount rate : Using a 10% discount rate for this project and the NVP model, determine whether this project should be accepted or rejected.
Find the electric potential at the center of a hollow metal : What is the electric potential at the center of a hollow metal sphere of outside diameter 14. cm which holds a net charge of 3.3 muC
Explain how to compute the disclosure and elevation of a : Reciprocal leveling gives the following readings in feet from a setup near A: on A, 2.071; on B, 8.254, 8.259 and 8.257. At the setup near B: on B, 9.112; on A, 2.926, 2.930 and 2.927. The elevation of B is 1099.600. Compute the disclosure and ele..
Explain what is the structure of the unknown compound : An unknown had the chemical formula C4H10O. It showed a positive chromic acid test, a positive lucas test in 5 minutes, and a positive iodoform test. What is the structure of the unknown compound

Reviews

Write a Review

Civil Engineering Questions & Answers

  Write a mass balance equation for this chemical

An industrial plant presently discharges a chemical (W=2000 * 106 gr/yr) to the lake. In addition, the inflow stream also contains the same chemical at a concentration of 15 mg/L. Note that the volumetric inflow and outflow are equal.

  Design the roof slab as a one-way slab system

Design the roof slab as a one-way slab system and use the worst case design scenario to determine the reinforcing for the entire roof

  Determine ft and fn

for this purpose replace this force by its equivalent of two forces at At Ft parallel and Fn perpendicular to the beam. Determine Ft and Fn.

  Explain the necessity of super elevation in the design

explain the necessity of super elevation in the design of horizontal curve also prove that rv=v2/{g(fs+e)}

  Ehermal conductivity of the radioactive wastes

The outer surface of the tank is cooled by air at 300 K with a heat transfer coefficient of 100 W/m2K. Determine the maximum temperature in the tank. Take the thermal conductivity of the wastes as 2.0 W/mK.

  What is your recommendation for the maximum size of coarse

What is your recommendation for the maximum size of coarse aggregate for the following situation?

  What is the elevation of lower point

A pre- engineering base line was run down a very steep hill.rather than measure horizontaily down hill with steel tape: surveyor measured the vertical angle with the theodolite and slope distance with 16m steel tape.

  Use differentiation to find a general expression

(a) Use differentiation to find a general expression for the rocket's velocity as a function of time, (b) When is the velocity zero?

  Determine the value of po

Determine the value of Po, as a funciton of H, for these two investment alternatives to be equivalent at an interest rate of i=15% per year.

  What percentage of the water evaporates

Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

  Designing the tangent vertical curve

Due to a street crossing a roadway, the elevation of the roadway at station 3 +413.760 must be at 129.388 m. Design the curve?

  What type of contract would you want and why

If you were asked to perform an excavation contract competitively with limited data, what type of contract would you want and why?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd