What is the length of consecutive wet days that has

Assignment Help Civil Engineering
Reference no: EM13542328

During the rainy season in a tropical country, the probability of a day being dry is 0.10. A dry day is defined as one without significant rainfall. Assuming that the number of days until the next dry day is geometrically distributed, what is the length of consecutive wet days that has a probability of occurence of no more than 0.05? Hint: calculate the probability of one wet day, then, 2, then 3, and so on until you hit a number of consecutive wet days with a probability of occurence of less than 0.05.

Reference no: EM13542328

Questions Cloud

Find the depth and the rate of flow in si units for critical : Water flows down a wide and shallow rectangular channel of concrete (n=0.015) laid on a slope of 0.004. find the depth and the rate of flow in SI units for critical conditons in the channel.
Calculate the total vertical stress pore water pressure : An investigation at a particular site reveald 10 m of clay overlying 2m of sand resting on bedrock.the water table was found to be at the ground surface and the piezometric level for the sand to be 2m above ground level
What roughness coefficient would be required to produce : Evaporation rate in a 3650 acre-lake is 100 acre-ft/d. If inflow to the lake is 25.2 cfs, determine the change in storage (ft) during 365 days.
Calculate the molar flow rate for each component in each : The fermenter stream you saw for the last problem is to be separated by distillation as shown below. Its composition is 85.0 mol % water (H2O, MW = 18.01), 10.0 mole % ethanol (C2H5OH, MW = 46.07), and 5.0 mol % sucrose (C6H12O6, MW =180.16). Its tot..
What is the length of consecutive wet days that has : During the rainy season in a tropical country, the probability of a day being dry is 0.10. A dry day is defined as one without significant rainfall. Assuming that the number of days until the next dry day is geometrically distributed.
What is the probability that one can travel to city three : There are two ways to get from City One to City Three, (a) directly or (b) via City Two. Let A be the event that the road from City One to Three is open. Similarly, B is for City One to Two and C is for City Two to Three. If snow is forecast for the ..
Calculate the viscous drag force on this plate : An engineer is designing a horizontal, rectangular conduit that will be part of a system that allows fish to bypass a damn. Inside the conduit a flow of water at 40 F will be divided
Compare the effectiveness of the zinc coating with a typical : Compare the effectiveness of the zinc coating with a typical epoxy coating on reinforcement. How does the epoxy coating protect reinforcement and what happens if the coating is nicked.
Consecutive wet days with a probability of occurence : During the rainy season in a tropical country, the probability of a day being dry is 0.10. A dry day is defined as one without significant rainfall. Assuming that the number of days until the next dry

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how long it will take at minimum to fill an glass

The drinking water needs of an office are met by large water bottles. One end of a .25 in diameter plastic hose is inserted into the bottle placed on a high stand, while the other end with an on/off valve is maintained 2 ft below th bottom of the ..

  Calculate the decay rate of radon in units of hr-1

Indoor Air quality is greatly affected by Radon, which can cause lung cancer. When we moved to Colorado, we tested the house for Radon and installed a radon mitigation system.

  Explain pump curve that illustrates the effect of throttling

Draw and explain a pump curve that illustrates the effect of throttling in the CLOSED direction (i.e., reducing flow) the discharge valve for a constant speed centrifugal pump installed in a cooling water system.

  Differential settlement between the centre line of the ring

Determine the differential settlement between the centre line of the ring beam and under the centre of beam. The inner and outer radii of the ring beam are 8m and 12m respectively.

  What is the discharge through the pipe for water temperature

A fire hydrant is supplied through a 6 inch cast iron pipe of 16,000 feet length. The total drop in pressure is limited to 35 psi. What is the discharge through the pipe for a water temperature of 80°F ((kinematic viscosity) = 0.93 × 10-5 ft2/sec)

  What is lowest grade possible for the constant-grade section

A tangent section of highway has a -1.0% grade and ends at station 0+1450and elevation 25m. It must be connected to another section of highway that has a -1% grade and that begins at station 1+345 and elevation 40m.

  Determine the allowable value of the tensile load p

A steel bar serving as a vertical hanger to support heavy machinery in a factory is attached to a support by the bolted connection. The main part of the hanger has a rectangular cross section with width b1 = 1.5 in. and thickness t = 0.5 in.

  A railway wagon weighing 40 kn and moving with a speed of 8

a railway wagon weighing 40 kn and moving with a speed of 8 kmh is stopped by a buffer of 4 springs whose allowable

  What is the range of values of a for which the body moves

The motion is described by the second Newton's law: m(d^2y/dt^2) + a(dy/dt) + ky = 0 where y is the body displacement in m, t is the time in s, a > 0 is the friction coeffcient in kg/s and k is the spring constant in kg/s2.

  Calculate the work necessary to compress air in cylinder

Calculate the work necessary to compress air in an isolated cylinder from a volume of 6 ft^3 to a volume of 1.2 ft^3. The initial pressure and temperature are 30.0 psia and 50 degree F, respectively.

  Determine the velocity and the acceleration of the particle

the path of particle p ios the elipse difined by relations r=2/(2-cosPIEt) and theta=PIEt, where r is exspressed in meters , tis in seconds nd thet is in radians. Determine the velocity and the acceleration of the particle whern t=0 seconds

  Draw the shear and bending moment diagrams for the beam

The beam ABC of length L has two different moments of inertia (2I in AB, I in BC) and a constant elastic modulus E. It is fixed at point A has a roller support at point B and a load P at C. a. Sketch the deflected shape of this beam.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd