What is the heat pumps heating coefficient of performance

Assignment Help Mechanical Engineering

Reference no: EM13718030

A heat pump is used to heat a home. It draws 3 kW of electrical power, and it extracts heat at a rate of 6 kW from the cold outdoor air.

A. At what rate does it add heat to the home?

B. What is the heat pump's heating coefficient of performance?

C. How long does it take to add 1 MJ of thermal energy to the home?

Reference no: EM13718030

Questions Cloud

The specific work of the compressor : An air compressor compresses air from 1 bar and 300 K to 5 bar and 540 K. The velocity at the inlet is 70 m/s and the velocity at the exit is 150 m/s. If To = 300 K and Po = 1bar.

Final state of water assuming the process to be adiabatic : A piston held by a pain in an insulated cylinder, contains 2 kg water at 100 degree C, quality 95%. The piston has a mass of 102 kg, with cross-sectional area of 100 cm^2, and the ambient pressure is 100 kPa. The pin is released, which allows the pis..

Water flows through a long tube of circular cross section : Water flows through a long tube of circular cross section at a mass flow rate of 0.01 kg/s. The heat flux through the wall is maintained uniformly at 3000 w/m^2. The water enters the tube at 20 C. The inside diameter is 7.5cm. Find the required lengt..

Determine the rate of heat rejection to the outside air : Determine the COP of a refrigerator that removes heat from the food compartment at a rate of 5040 kJ/ h for each kW of power it consumes. Also, determine the rate of heat rejection to the outside air.

What is the heat pumps heating coefficient of performance : A heat pump is used to heat a home. It draws 3 kW of electrical power, and it extracts heat at a rate of 6 kW from the cold outdoor air. At what rate does it add heat to the home? What is the heat pump's heating coefficient of performance?

What is the total pressure at the front of the beam : A river (of water) is flowing at a velocity of 1.2 m/s at 25 C. If a large beam is placed in the river to support a bridge, what is the total pressure at the front of the beam (the side facing upstream) in kPa at a depth of 2 m when the atmospheric p..

Hot combustion gases flow into a nozzle at low velocity : Hot combustion gases flow into a nozzle at low velocity with an enthalpy of 1,000 kJ/kg at a mass flow rate of 1 kg/s. At the nozzle exit, the enthalpy is reduced by a factor of 2. What is the thrust experienced by the nozzle as a result of the exhau..

Determine the cop ot the cycle and the total cooling load : An ideal vapor-compression refrigeration cycle uses r-134a as the working fluid is used to cool a brine solution to -5 C. This solution is pumped to various buildings for the purpose of air conditioning. The refrigerant evaporates at -10 C with a tot..

Parting line in injection molding : The parting line in injection molding is which one of the following: (a) the lines formed where polymer melt meets after flowing around a core in the mold, (b) the narrow gate sections where the parts are separated from the runner, (c) where the clam..

User Account

All Pages