What is the fluids specific volume

Assignment Help Mechanical Engineering
Reference no: EM13706624

Given a volume 4.42 m by 4.84 m by 4.82 m, filled with a fluid having a mass 57.52 kg. What is the fluid's specific volume?

Reference no: EM13706624

Questions Cloud

Find the first law efficiency of the cycle : A steam plant operates on a Rankine cycle. The following conditions are given: The steam exits the boiler at 550C and 15MPa. The heat supplied to the boiler is at 1000C. The condenser pressure is 8kPa. The flow exits the condenser with 4C of subcooli..
What is the efficiency of this fan ya motor system : A fan with a diameter of 12 inches operates at a voltage of 120V with a current draw of 0.5 amps. The manufacturer claims the average velocity of air leaving the fan is 33.1 ft./s under stadard conditions. Standard air has a density of 0.075 lb mass ..
Useful final-to-initial mass ratio versus exhaust velocity : Consider a cargo vehicle that will travel back and forth between the moon and LEO that is propelled by an electric propulsion system on a slow spiral trajectory. Assume that the characteristic velocity change (?v) for this mission is ?v=6,800 m/s.
Find the enthalpy of the exit steam : Saturated steam at 230 degrees F, 20.78 psia and 19.386 ft cubed per pound of mass enters a compressor with an internal energy of 108.26 Btu/lb of mass and is compressed to 80 psia. the mass flow rate is 50 lb mass per hour. Heat loss from the compre..
What is the fluids specific volume : Given a volume 4.42 m by 4.84 m by 4.82 m, filled with a fluid having a mass 57.52 kg. What is the fluid's specific volume?
A block is made of a material with a specific gravity : A block is made of a material with a specific gravity of 1.3. If the block has a volume of 0.52 m3, what is the mass of the block?
A solid cylinder with a radius : A solid cylinder with a radius of 5.0 cm and a length of 10 cm is cut in half lengthwise. What is the surface area of one of the two resulting objects?
What is the rotation rate : What is the rotation rate (in radians per second) of 17.0 inch diameter wheels on a vehicle traveling at 211 inches per second?
A block of wood floats in water with half : A block of wood floats in water with half its volume below the surface. The specific weight of the wood in lbf/ft3 units is about

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  An electric heater in the tank transfers energy to the

a 2 phase liquid-vapor mixture of 2 kg of water is contained in a rigid insulated tank initially with a pressure of 1

  A gas in an insulated tank is separated from an evacuated

a gas in an insulated tank is separated from an evacuated region by a membrane. the membrane is removed and the gas is

  A sky diver with a mass of 70 kg jumps from an aircraft the

a sky diver with a mass of 70 kg jumps from an aircraft. the aerodynamic drag force acting on the sky diver is known to

  Find the temperature and the cooling rate of the wire as a

a wire of radius r length l and initial temperature ti is cooled by a fluid of temperature tf at time t0. the heat

  An airplane used to drop water on bushfire is flying

an airplane used to drop water on bushfire is flying horizontally in a straight line at 180 mih at altitude of 300 ft.

  Determine 1 temperature at the outlet 2the velocity at the

r-134a at 800 kpa and 100 c enters an adiabatic nozzle steadily with a velocity of 20ms and leaves as sat-v at 400 kpa.

  The height from the ground to the top of the stairs is 2 ft

a civil engineer must design a wheelchair accessible ramp next to a set of steps leading up to a building. the height

  A ship has an engine that rotates clockwise when viewed

a ship has an engine that rotates clockwise when viewed from the front. it has an effective moment of inertia of 250 kg

  Determine the rotation speed in rpm if the test is to

a prototype disk brake for a bicycle was designed and consists of a pair of pads area 5 cm x 1 cm pressed against

  The collar at a can freely slide in the y-direction and can

a vertical bar ed has a circular cross-section and is fixed at e. member abc is a single member that lies on the

  The mass flow rate is 556 lbs and the isentropic turbine

water vapor at 800 lbfin.2 1000 degrees f enters a turbine operating at steady state and expands to 2 lbfin.2 the mass

  Determine changes in composition of a fluid

What information has to be obtained in order to ensure that the method will be a satisfactory one and determine changes in composition of a fluid. Define what is meant by refractive index, and give the relationship between the incident and refracte..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd