User Account

All Pages

What is the firms cost of capital before taxes

Assignment Help Civil Engineering
Reference no: EM13557114

A firm's stockholders expect a 15% rate of return, and there is a $12M in common stock and retained earnings. The firm has $5M in loans at an average rate of 7%. The firm has raised $8M by selling bonds at an average rate of 6%. What is the firm's cost of capital:

(a) Before taxes?

(b) After taxes with a tax rate of 35%?

Reference no: EM13557114

Questions Cloud

What are the relative amounts of the primary or proeutectoid : When the 1.10 wt% C steel is cooled under equilibrium conditions from 925 (deg C), (i) what are the relative amounts of the primary or proeutectoid phase, the pearlite, and the total ferrite phase immediately below the eutectoid temperature
Show how the gibbs energies of each of these phases : The standard molar entropies of water ice, liquid and vapor are 37.99, 69.91, and 188.83 J K-1mol-1, respectively. On a single graph, show how the Gibbs energies of each of these phases vary with temperature between – 20 C and 150 C
Calculate the maximum mixing height in meters : Compute the critical buckling load for a 2.5m timber column of full size square section 0.10m x 0.10m. The column has pinned ends(k=1). Assume the modulus of elasticity is 12Gpa and that the Euler formula applies.
Determine a composite scs runoff curve number : Determine a composite SCS runoff curve number for a 600-acre basin that is totally within soil group C. The land use is 40 percent contoured row crops in poor hydrologic condition and 60 percent native parture in fair hydrologic condition.
What is the firms cost of capital before taxes : A firm's stockholders expect a 15% rate of return, and there is a $12M in common stock and retained earnings. The firm has $5M in loans at an average rate of 7%. The firm has raised $8M by selling bonds at an average rate of 6%. What is the firm's co..
Calculate work done : Tank A has a volume of 100 liters and contains saturated vapor r-134 at 30C. With the valve open slightly flow enters cylinder B. a pressure of 200kpa is required to lift piston in b. the process ends when the pressue at A drops to 200kPa.
What is the elongation of a rectangular bar : What is the elongation of a rectangular bar (cross section 2 inch * 2 inch length 4 ft) When it is subjected to an axial load of 80,000 lbs. Assume the material of the bar has the following properties G = 7,700 KSI, V =0.30
Calculate the active and passive pressures at the lower end : A line of sheet piling is driven 4m into a firm clay and retains, on one side, a 3m depth of fill on top of the clay. Water table level is at the surface of the clay. The unit weight of the fill is 18kN/m3 and the saturated unit weight of the clay is..
Determine the factor of safety with respect to shear failure : A footing 3m X 3m carries a pressure of 500 kN/ m2 at a depth of 1m in a sand substrate. The saturated unit weight of the sand is 20 kN/ m3 and the unit weight above the water table is 18 kN/ m3

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the concentration of mlvss in the activated sludge

The concentration of Chemical Oxygen Demand (COD) in the effluent from this system is 25 mg L-1. The growth rate of the organisms in this case is 0.9 days-1. The activated sludge tank has a volume of 50 m3 and the flow rate through it is 500 m3 da..

  Pulling automobile by means of two ropes

A disabled automobile is pulled by means of two ropes as shown. The tension in AB is 400 lb and the angle is 20. knowing that the resultant of the resultant of the two forces applied at A is directed along the axis of the automobile, determine by ..

  Determine acceleration of rod and reaction at a and b

The motion of the 2.5-kg rod AB is guided by two small wheels which roll freely in horizontal slots. If a force P of magnitude 8 N is applied at B, determine (a) the acceleration of the rod, (b) the reaction at A and B.

  Develop the relation between bulk unit weight

develop the relation between bulk unit weight, specific gravity, void ratio and weight of water.

  Determine the shear-thrust and moment in the arch at point c

The three hinged arch is composed of segments of a circle. Support points A and D are not at the same level.Determine: (a) the horizontal and vertical components of reaction at A and D.

  Determine magnitude and direction of objects acceleration

8 Forces of 10.0 N north, 20.0 N east, and 15.0 N south are simultaneously applied to a 4.00 kg mass as it rests on an air table. Determine the magnitude and direction of the object's acceleration.

  Calculate carbonate-noncarbonate and total hardness

Calculate carbonate, noncarbonate, and total hardness Na+ = 27.8 mg/L Cl- = 35.6 mg/L Ca+2 = 48mg/L CO3-2 = 30 mg/L Mg+2 = 12mg/L HCO3- = 61 mg/L K+ = 12 mg/L SO4-2 = 48 mg/L

  What size of orifice is needed to produce a change in head

What size of orifice is needed to produce a change in head of 9m for a discharge of 2 m^3/s of water in a 1-m diameter pipe.

  Determine force necessary for system to be in equilibrium

The mass of each pulley of the system is 50 kg, and mass of the suspended object A is 160 kg. Determine the force necessary for the system to be in equilibrium? Be sure to draw complete free body diagram(s) for full credit.

  Determine the rate of flow-unconfined aquifer

In an unconfined aquifer having K = 30/m/day, two observation wells, 3km apart, have water levels of 50 and 40 m, respectively, above the base of the aquifer. Determine the rate of flow.

  What is the mean velocity of air in the micro-channel

A micro-channel of diameter 0.5 mm and length 750 mm is connected to a plenum. A fan produces a negative gage pressure of -1.5 inch H2O in the plenum and draws air at 20oC into the micro- channel.

  Explain what is the hydraulic residence time of the river

An industry is illegally discharging benzene into a river. The concentration in the river at the point of discharge is 0.2 mg/L. A drinking water treatment plant (DWTP) is located 1.5 km downstream. The water velocity in the river is 0.35 km/day.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd