What is the final speed of the cart

Assignment Help Physics
Reference no: EM13957898

In a shipping company distribution center, an open cart of mass 53.0 kg is rolling to the left at a speed of 5.40 m/s (see the figure ). You can ignore friction between the cart and the floor. A 14.0 kg package slides down a chute that is inclined at 37 degrees from the horizontal and leaves the end of the chute with a speed of 3.10 m/s . The package lands in the cart and they roll off together. See attached figure.

A) If the lower end of the chute is a vertical distance of 4.00 m above the bottom of the cart, what is the speed of the package just before it lands in the cart?

B) What is the final speed of the cart?

368_Fig1.jpg

Reference no: EM13957898

Questions Cloud

Capable of producing within acceptable limits : Adjustments were made in the process at the Mach4 Tool Co. discussed in Problem 17 and 25 more samples were taken. The results are given in the worksheet tab Prob. 8-18 in the Excel file C08Data.xlsx on the Student Companion Site for this chapter. Wh..
Why are opportunity costs relevant when making decisions : Why are opportunity costs relevant when making decisions?
Final simplex tableau for the above problem : a. Formulate the given problem as a linear programming problem? b. The following is the final simplex tableau for the above problem:
Civil case resulted in subsequent criminal charges : Use the Internet to research a civil case in which either a criminal case resulted in a subsequent civil case for damages, or a civil case resulted in subsequent criminal charges. Be prepared to discuss.
What is the final speed of the cart : If the lower end of the chute is a vertical distance of 4.00 m above the bottom of the cart, what is the speed of the package just before it lands in the cart?
Which of these three options pass the utilitarian test : Hard choice in Hondo.7 George is manager of an Ardnak Plastics plant in Hondo, Texas. It employs several hundred persons, a large fraction of the local workforce. George’s boss, Bill, telephones him from head- quarters in El Paso with the news that t..
Benefits of using metrics in process safety management : Describe four characteristics of effective metrics. Provide an example of a leading metric and an example of a lagging metric that meet these criteria.
Support the use of market prices or cost based prices : Support the use of market prices or cost-based prices for charging clinics for tests performed by the pathology laboratory.
Determine the magnitude and direction of the velocity : A 0.30 kg puck, initially at rest on a frictionless horizontal surface, is struck (inelastically) by a 0.20 kg puck that is initially moving along the x-axis with a velocity of 2.0 m/s. After the collision, the 0.20 kg puck has a speed of 1.0 m/s ..

Reviews

Write a Review

Physics Questions & Answers

  How much work is done in pushing the chest

How much power is needed to push a 85kg chest at 0.72m/s along a horizontal floor where the coefficient of friction is 0.76

  What was the speed of the projectile

A projectile is shot from the surface of Earth by means of a very powerful cannon. what was the speed of the projectile when it left the cannon

  The bullet remains embedded in the block which is observed

a 4.50g bullet is fired horizontally into a 2.35kg wooden block resting at the bottom of a 25 degree inclined surface.

  Determine change of exergy of fluid and energy destroyed

the pressure and temperature of steam entering an adiabatic turbine are 4000kPa and 400 degrees C, respectively. if the pressure and the temperature of the working fluid at the exit are 200kPa and150 degrees C

  Compute the width of the square well

An electron is in the ground state of an infinite square well. The energy of the ground state is E1 = 1.11 eV. What is the width of the square well

  Question1a roller coaster car moves 248 ft horizontally and

question1a roller coaster car moves 248 ft horizontally and then rises 121 ft at an angle of 30deg above horizontal. it

  Evaluate the total energy stored in the capacitor

a parallel-plate capacitor with plate are A and separation x has charges +Q and -Q on its plates. The capacitor is disconnected from the source of charge, what is the total energy stored in the capacitor

  Illustrate what is the coefficient of static friction

Illustrate what is the coefficient of static friction between the chair and the floor? What is the coefficient of kinetic friction between the chair and the floor?

  What is the thermal conductivity of this metal

A metal rod with a diameter of 2.30 cm and length of 1.10 m has one end immersed in ice at 32oF, what is the thermal conductivity of this metal and Identify the metal

  Find magnitude and direction of total vector force exerted

A curve in a road forms part of a horizontal circle. As a car goes around it at constant speed 14.0 m/s, Find the magnitude and direction of the total vector force exerted on driver if the speed is 24.0 m/s instead

  Find the rate of rotation of the wheel

When a guitar string is sounded along with a 436 Hz tuning fork, a beat frequency of 5Hz is heard. When the same string is sounded along with a 434 Hz tuning fork, beat frequency is 7.00 Hz. What is the frequency of the string.

  A charge q1 31 times 10-6 c is placed at the origin charge

a charge q1 3.1 times 10-6 c is placed at the origin. charge q2 -6.8 times 10-6 c is placed on the x-axis at x -0.20

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd