Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A toothpaste factory situated on a large river disposes of a waste water containing villiamite (NaF) to the river on a continuous basis. The minimum flow in the river is 210 m3/s, and the discharge rate from the treatment plant is 12.5 m3/s. The river temperature averages 18°C and the waste discharge is 80°C.
a. If the maximum acceptable limit for the pollutant is 1.0 ppm in the downstream river, and the background concentration of the pollutant upstream is 0.4 ppm, what is the maximum concentration, in M, that can be safely released from the plant?
b. What is the final river temperature downstream? Assume that the density of the waste stream is 1000 kg/m3.
Determine the total crop water requirement including the leaching ratio of a corn crop with a ECt of 1.7mmhos cm-1 if the ECiw of the irrigation water and precipitation is 5 and 0 mmhos cm-1 respectively
the coefficient of the restitution for the collision is e = 0.3, and friction is negligible. if the time duration of the collision is 0.025 s, determine the average impact force which is exerted on the 3 kg body.
The center to center spacing to the two tanks is 14 m. The new tank imparts 150 kPa at the ground surface. Find the increase in vertical stresses due to the weight of the two tanks mid- way between the two tanks at the center of the clay layer.
Does the presence of Mg2+ significantly interfere with the determination of Ca 2+ by the EDTA titration?
Water with a static pressure of 1.96kN/M2 flows through an 800 mm diameter pipe. A pitot tube pressure gage in this pipe reads a pressure of 5.88 kN/M2. Determine the velocity (V)
a vehicle pulls out onto a single lane highway that has a flow rate of 280 vehhr poisson distributed. the driver of the
A 500 L (132 gal) tank contains 255 mg/L 2,4,6-trichlorophenol dissolved in trichloroethylene (TCE). What is the 2,4,6-trichlorophenol concentration in ppm Assume the temperature of the system is 20 degrees C.
If the diameters of ball bearings are normally distributed with mean 0.6140 inches and standard deviation 0.0025 inches, determine the percentage of ball bearings with diameters,
To protect the channel from erosion, the normal flow velocity for the design discharge has to be reduced to 7.0 fps or below, and the flow Froude number must be reduced to 0.80 or below.
A long concrete retaining wall with 2.4X10^3 kg/m^3 density is used to support a soil embankment. Assuming the soil behaves as a fluid with 1.5X10^3 kg/m^3 density, determine the required coefficient of friction so the wall does not slip along its ba..
Draw the influence line for the tension in the cable as a point load travels across the beam. Find the maximum tension in the cable due to a live point load of 6 k on the beam.
a paved parking lot section has a uniform slope over a length of 100 m in the flow direction from the point of a
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd