What is the final angle of the shaft

Assignment Help Electrical Engineering
Reference no: EM131087122

An incremental optical rotary encoder has 720 slots. Starting from the reference point, the disk turns 200 slots CW, then 80 slots CCW, then 400 slots CW. What is the final angle of the shaft?

Reference no: EM131087122

Questions Cloud

Single inspection station before proceeding : Vehicles arrive at a border crossing and must be inspected by a single inspection station before proceeding. The vehicles arrive at the station according to a Posson disribution at a rate of 882 vehicles/hour (time between arrivals is exponentiall..
Measure success of the organization : Develop a business proposal to your Supply Chain VP defining the metrics to measure success of the organization. The proposal must include relevant points aligned with the company objectives. This must be an existing organization.
Responsible for the initial interview : Assume you are the HRM responsible for the initial interview. What would you be looking for from the applicant during the initial interview? Explain.
The probability of a point falling outside the control limit : Suppose a control chart is constructed so that the probability of a point falling outside the control limits when the process is actually in control is .002. What is the probability that ten successive points (based on independently selected sampl..
What is the final angle of the shaft : What is the final angle of the shaft?
Calculate the value of expectation damages : Calculate the value of expectation damages for the first buyer and show that it gives the seller the correct incentives regarding breach of the original contract.
A control chart for thickness of rolled-steel sheets : Refer to Exercise 1 and suppose the ten most recent values of the quality statistic are .0493, .0485, .0490, .0503, .0492, .0486, .0495, .0494, .0493, and .0488. Construct the relevant portion of the corresponding control chart, and comment on its..
Effort for a sport organization to implement : Is it worth the time and effort for a sport organization to implement procedures tomanage the risk of an incident such as a lightning strike where the likelihood of death orinjury is low but the potential severity of injury is high? Why
What is the current angle of the encoder shaft : What is the current angle of the encoder shaft?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is total input current and power factor of transformer

Two single phase transformers are connected in parallel with the following parameters. Transformer A, rated at 60 kVA Rc=250 k Ohm Req=25 Ohm Xm=45 k Ohm Xeq=150 Ohm

  What is the instruction to initialize the sp register

With regard to assembly language and the HCS12: What is the instruction to initialize the SP register Why do we initialize that register What is the reason we initialize it with the value $4000 for this microcontroller

  How many electrons pass through a cross section of the wire

The charge of an electron is 1.60 x 10-19 C. A current of 2 A flows in a wire caried by electrons. How many electrons pass through a cross section of the wire each second

  Piston-cylinder assembly with a paddle wheel

Air is contained in a well-insulated piston-cylinder assembly with a paddle wheel connected to an external electric motor. Initially, the volume of the air in the cylinder is 0.02 m3, the pressure is 1.5 bar, and the temperature is 400K. The elect..

  Power also noise calculations using decibel conversions

A radio receiver has a noise power N = kTB watts, with T = 100 K and B = 1.0 MHz. The value of k is 1.38 x 10^-23 J/K. What is the noise power in dBW?

  Sketch the spectrum of modulator output of impulse function

An AM modulator is operation with an index of 0.4. The modulation input is: m(t) = 4cos (3πfmt) + 2cos (5πfmt) + 4cos (7πfmt) What is the efficiency of the modulator Sketch the spectrum of the modulator output showing the weights of all impulse funct..

  How do tv remote signals and projector remote signals differ

How do TV remote signals and projector remote signals differ?

  Find the system-specific part of the response-output

Consider the first-order linear differential equation y(t) + 5 (dy(t) / dt) = x(t) Compute the zero-input response (general solution of the homogeneous equation) to find the system-specific part of the response

  What is the average total cost for the machine in the system

The failed machine will be immediately replaced with a brand new one upon the failure and the replacement time is negligible. Each machine will cost $100,000 dollars and the system is designed to run for 5 years.

  Design a circuit to duplicate the input-output response

Suppose that you have graduated from College with an engineering degree and you start working for a local contracting company. For your first job, you are asked to design a circuit to duplicate the input-output response for small-amplitude inputs ..

  Determine ian-ibn-icn-vab-vbc and vca in phasor form

3-phase-Y-connected load of 40,000W at 0.8 PF lag is supplied by a three-phase Y-connected source of 500V. Find the current and phase voltages. Assuming Van as ref. Determine Ian, Ibn, Icn, Vab, Vbc, and Vca in phasor form.

  Identify the interval of interest for performing convolution

Identify the intervals of interest for performing the convolution {x[n]*h[n]} on the following LTI system. This experiment requires that you write the summations for each interval of interest, but does not required you to simplify the summations.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd