What is the estimated collection efficiency at 250f

Reference no: EM13545619

Our ESP is collecting 95% of the particles in our exhaust stream. We are under pressure to improve its performance. It has been suggested that if we were to cool the inlet gas fron the present 600F to 250F, the performance would improve. What is the estimated collection efficiency at 250F, if we keep the mass flow rate constant, do not change any of dimensions of the ESP, and if changing the temperature does not change the drift velocity,w?

Reference no: EM13545619

Questions Cloud

Determine the rate at which heat must be transferred to the : Saturated liquid water at 1.0 MPa is throttled adiabatically to a pressure of 0.4 MPa. If the change is kinetic energy is negligible, what percentage of the water evaporates during this throttling process?

What is the local loss coefficient of the basket strainer : A basket strainer is installed in a 15-cm diameter pipe. Pressure gauges are installed immediately upstream and downstream of the basket strainer. When water flows at 100 m3/hr, the pressure gauge immediately upstream of the basket strainer measures ..

Determine the maximum water hammer pressure if the initial : A 1000 ft long steel pipe carries water from a reservoir with a water elevation at 826 ft. The pipe has a diameter of 12 in. with a wall thickness of .5 in. A gate valve at the downstream end is slowly closed during a half-mintue period

Calculate the total head loss for water flowing at 10 : Calculate the total head loss for water (25°C) flowing at 100 m3/hr as shown in the following figure. The total flow length is 250 meters and the pipe is 15-cm diameter cast iron pipe

What is the estimated collection efficiency at 250f : Our ESP is collecting 95% of the particles in our exhaust stream. We are under pressure to improve its performance. It has been suggested that if we were to cool the inlet gas fron the present 600F to 250F, the performance would improve.

Determine the design load for strength and service ability : Determine the design load for strength and serviceability limit states (short-term and long term), for a steel beam in a residential building with the following data;

What pipe diameter is needed to discharge gasoline : Gasoline is being discharged from a pipe at point 2 at elevation 66.66 m. Pint 1, located 965.5 m along the pipe from point 2, is at elevation 82.65 m

Determine the final temperature of the steam and the heat in : Two kilograms of steam at 300kPa and a quality of 75% are heated in a closed container until a pressure of 600kPA is reached. Determine the final temperature of the steam and the heat input. Find the pressure at which saturated water vapor is obtaine..

Determine the min coefficient of static friction between : Determine the min coefficient of static friction between tires and the road surface so that the 1.5Mg car does not slide as it travels at 80km/h on the curved road. Neglect the size of the car.

User Account

All Pages