What is the effective voltage of the signal

Assignment Help Electrical Engineering
Reference no: EM13249231

1.An electronic device that will generate and combine (in phase) 400 Hz, 800 Hz, 1200 Hz, 1600 Hz, 2000 Hz,
and 2400 Hz signals will produce a(n)
A.sine wave.
C.imperfect sawtooth wave.
B.perfect sawtooth wave.
D.imperfect square wave

2.a specific type of relaxation oscillator that has,in its only stable state,one transistor stage conducting and one of is known as
a.bistable
b.harmonic generator
c.single shot
d. clamper

3.in an RC series circuit,the total resistance found to be 250k Ohms. How long will it take the 300 microfarad capacitor to charge to a point very close to its maximum voltage?
a. .833 seconds
b. 6.25 minutes
c. 1.2 microseconds
d. 6.25 seconds

4.An amplifier output is being evaluated by a technician. The output is found to be a sine wave. The measured time lapse from one sine-wave peak to the next is 5 milliseconds. The signal

a.has a period of 10 milliseconds
b.has a frequency of 200 Hz.
c.can't be a sine wave as they don't have such short periods
d.has a period of 2.5 milliseconds

5.A PNPN diode is commonly found in oscillator circuits to produce a
a. square-wave pulse train
b.pure sine wave
c.perfect square-wave
d.sawtooth wave

6.An AC voltage signal is observed on an oscilloscope to have a peak-to-peak value of 240V.What is the effective voltage of this signal?
a.120V
b.168V
c.84V
d.240V

7.A group of sine waves with frequencies of 1000,2000,3000,4000, and 5000 Hz combine to form a nonsinusoidal wave. The wave with the longest period is
a.a square-wave
b.fifth harmonic
c.second harmonic
d.fundamental frequency

Reference no: EM13249231

Questions Cloud

Determine the proper orientation of the coil : Bats are capable of navigating using the earth's field-a plus for an animal that may fly great distances from its roost at night. What is the proper orientation of the coil
What would be the increase in profit : If purchases were 45% of sales and other expenses were 45% of sales, what would be the increase in profit if, through better purchasing, the cost of purchases was reduced to 43% of sales.
Determine the distance traveled during the first 10s : an automobile travels 1200ft in 30s while being accelerated at a constant rate of 1.8 ft/s^2. Determine (a) its initial velocity, (b) its final velocity, (c) the distance traveled during the first 10s
State the pressure of air in the lungs if the gas expands : A scuba diver 40 ft below the ocean surface inhales 50.0 mL of compressed air mixture in a scuba tank at a pressure of 3.00 atm and a temperature of 8 degrees C
What is the effective voltage of the signal : An amplifier output is being evaluated by a technician. The output is found to be a sine wave. The measured time lapse from one sine-wave peak to the next is 5 milliseconds.
What is a good safety stock : A customer who is not satisfied at your store does not wait and simply drives down the street to a competitor.
Obtain the velocities of balls : Two identical balls are traveling toward each other with velocities of -4.1 m/s (ball A) and +9.5 m/s (ball B), Obtain the velocities (magnitude and direction) of balls
State the minimal external voltage of electrolysis of molten : What is the minimal external voltage one must supply in order to perform the electrolysis of molten CaCl2. Suggest a means for supplying this energy.
Find the velocity of the ball before the collision : A ball is attached to one end of a wire, the other end being fastened to the ceiling. The wire is held horizontal, Find the velocity (magnitude and direction) of the ball just before the collision

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is 3db frequency of closed-loop inverting amplifier

Sketch the Bode plot (closed-loop gain vs. frequency, and closed-loop phase vs. frequency) of the amplifier. Label the gains at 0.1*f3dB, f3dB, and 10*f3dB using dB-scale. Also indicate the values of the phases at these frequencies.

  Formulate the differential equation model for a motor

Formulate the differential equation model for a motor having inductance L and rotational inertia J, and electrical resistance Rw and frictional resistance Rf, driving a frictional load, Rl.

  Develop contoller as sequential ckt using min num of d-ff

To develop contoller as a sequential circuit using minimum number of D flip-flops and the minimum number of external gates. the controller should set the values of the control lines appropriately to drive the combinational logic circuit.

  Compute the transfer function

In this project we will consider the control of a synchronous generator supplying electricity to the grid.

  What is the most common used op-amp in the industry

1) What are some practical op-amp applications Can you give example and explain why the bop-amp was used in your example 2) What is the most common used op-amp in the industry

  Determine the system impulse response in time domain

Determine the system impulse response in time domain and draw its root locus and comment on system stability.

  How to adjust the inductance in an lc oscillator

The tuning control is required to provide a uniform, linear change in frequency for a fixed rotation of the knob, e.g., 25 kHz per revolution at any operating frequency.  You are considering three options for controlling the frequency

  Calculate the internal resistance of the battery

Determine experimentally the value of a resistor that when placed across the battery will make a measurable change in measured battery voltage. Keep the voltage decrease from open circuit value to 10% or less.

  What will be the output amplitude of a sine wave

a lowpass butterworth filter has a corner frequency of 1 khz and a roll-off of 24 db per octave in the stopband. If the output amplitude of a 3 khz sine wave is .1 V, what will be the output amplitude of a 20 khz sine wave if the input amplitudes ..

  What is the time required for the capacitor voltage

A capacitor in an RC circuit with R = 5.00 ohm and C = 6.00 mF is being charged. What is the time required for the capacitor voltage to reach 86.5 percent of its steady-state value

  What is the range of the sensor voltage outputs

A manufacturer specification sheet lists the transfer function of a pressure sensor as 45±5% mV/kPa with a time constant of 4±10%. A highly accurate test system applies a step change of pressure from 20 kPa to 100 kPa.

  Determine minimum value of the dc open-loop gain required

An op-amp is to be selected for an inverting amplifier to be used at dc and very low frequencies. A closed-loop nominal gain of -100 is desired. Specification indicate that the error due to finite open-loop gain cannot exceed 0.1dB.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd