What is the dry unit weight, the saturated unit weight

Assignment Help Civil Engineering
Reference no: EM13559047

1.A river is 6 m deep. The riverbed material has a saturated unit weight of 19.5kN/m3. What is the effective vertical stress 12 m below the water surface?

2.The solids in a specimen have a specific gravity of 2.65. If the oven-dry mass of the specimen is 25 kg, what is the volume of the solids in it?

3.What is the dry unit weight, the saturated unit weight, and the buoyant unit weight, of a soil having a void ratio of 0.5 and a value of Gs of 2.7?

Reference no: EM13559047

Questions Cloud

How many grams of ethane remainin the flask : A flask with a volume of 1.50 L, providedwith a stopcock, contains ethane gas (C2H6)at 300 K and atomospheric pressure (1.013 x 105Pa). How many grams of ethane remainin the flask
Literature review and report : Literature Review and Report
Determine the water content : In its natural condition a soil sample has a mass of 2400 g and a volume of 1.15 X 10-3 m3. After being completely dried in an oven the mass of the sample is 2225 g. The value of Gs for the soil is 2.7. Determine the:
What will be this maximum current : as LC circuit consists of a capacitor with C = 3.4 x10-6 F and an inductor with L = 0.080 H. What will be this maximum current
What is the dry unit weight, the saturated unit weight : What is the dry unit weight, the saturated unit weight, and the buoyant unit weight, of a soil having a void ratio of 0.5 and a value of Gs of 2.7?
Determine what is the mass of the aluminum cup : An aluminum cup contains 225 g ofwater and a 40 g copper stirrer, all at 27°C. Calculate the mass of the aluminum cup
Determine the cohesion and the angle of friction of the soil : Undrained shear box tests were carried out on a series of soil specimens with the following results:Total normal stress (kPa) Total shear stress at failure (kPa)
Determine how deep is the dent made in the car : A 30-kg shopping cart full of groceries sitting at the top of a2.0-m hill begins to roll until it hits a stump at the bottom ofthe hill. How deep is the dent made in the car?
Determine the increment of vertical stress there : Constructing the foundation causes changes in the levels of vertical stress at all points in the soil. One such point lies at the centre of the footing plan, and is at a depth of 10 m. Determine the increment of vertical stress there.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Radioactive waste from a clinical laboratory

A radioactive waste from a clinical laboratory contains 0.2 μCi (microcuries) of calcium-45 (45Ca) per liter. The half-life of 45Ca is 152 days.

  List the set of all possible combinations of vehicles

The traffic that makes a left turnat an intersection consists of two types of vehicles, Type A andB. A type A vehicle is twice the length of the type B. THe left turn lane can accommodate ten vehicles of type B, five oftype A.

  Find the change in depth and in absolute water level produce

Find the change in depth and in absolute water level produced by a) a smooth upward step of 1 ft b) a smooth donward step of 1 ft, in the channel bed c) find the maximum allowable size of thw upstream flow to be a possible as specified

  What is the minimum possible value for this pressure

Part of a vertical piping system consists of 8 ft of 4 in diameter, connected to 8 ft of 3 in diameter above, and connected to 8 ft of 2 in diameter above that. Water at 60 F flows up the pipe (no downward flow occurs)

  Determine the flow rate per unit width of aquifer

The aquifer is inhomogeneous with K = 12+0.006x, where x =0 at point 1, and the piezometric heads at point 1 and 2 are 14.2 m and 18.8 m, respectively measured above the upper confining layer.

  What force is necessary to lift a thin 25-mm diameter ring

What force is necessary to lift a thin 25-mm diameter ring out of :

  Is this close to the transmission capacity within the system

Say the availability of supply is 60% to, and through Tank “A”, and 40% supplying tank B. Is this close to the transmission capacity within the system to J and C? If not, what do you suggest?

  What horsepower must be supplied to the pump in order

A pump of 80% efficiency lifts water from one large open tank to another; the difference in water surface elevations is 20 feet. The pipe is relatively smooth (f = 0.0122), and has 3 elbows, each with a loss coefficient of 2/3.

  What are the important findings

What are the important findings in Austin Road Co. v. OSHRC and Builders Steel Co. v. Marshall? Your response should be approximately 200 - 300 words and include a reference citation for your response.

  Prepare a capstone report for designing of steel building

prepare a capstone report for designing of steel building using aisc 14 edition manual. the capstone report contents

  Determine the concentration of ubod in the effluent

If the length of the river connection between the two lakes is equal to 3km and the velocity in the river is equal to 0.4 m/s, determine the concentration of UBOD in the effluent from the second lake.

  What is the bod concentration at the outflow of the pond

A pond is used to treat a dilute municipal waste-water before the liquid is discharged into a river. The inflow to the pond has a flow rate of Q = 4,000 m3/day and a BOD concentration of Cin = 25 mg/L.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd