What is the distribution of the number of systems that

Assignment Help Civil Engineering
Reference no: EM13563634

A hydrologic structure (e.g. a dam or a dike) is said to be designed for the N-year flood if it has a capacity which will be exceeded only by a flood equal oto or greater than N-year flood. The magnitude of the N-year flood is that which is exceeded with probablility 1/N in any given year, assuming the succesive annual floods are independent.

a) What is the probability that exactly one flood equal to or in exces of the 40-year flood will occur in a 40-year period?

b) What is the probability one or more floods will exceed the 40-year in 40 years?

c) If an agency design 20 similar, but independet, hydrologic systems (i.e. systems at widely separated locations), for its particular 40-year flood, what is the distribution of the number of systems that will fail at least once within th fist 40 years after their construction?

d) In 1995 the 40 year flood was estimated to be a particular size. In the subequent 10 years, two floods were observed in excess of that size. Because of this people question the correctness of the original estimate.

1) If the original estimate was correct, what is the probability of 2 such floods in 10 years?

2) If the original estimate was correct, what is the probability of 2 or more such floods in 10 years?

Reference no: EM13563634

Questions Cloud

Find fhe probability that the out-of-control condition : A quality characteristic is monitored by a control chart designed so the probability that a certain out-of-control condition will be detected on the first sample following the shift to that state is 1-beta. Find the following:
Evaluate how much work is done by the worker : A mail bag with a mass of 124 kgis suspended by a vertical rope 8.0 mlong. How much work is done by the worker in moving the bag to thisposition
Calculate the alkalinity as cac03 of water that contains : Select the lightest available W14 section to support the axial compression dead load of PD= 140 k and a live load of PL = 120 k if the length is equal to 14 ft and A992 steel is used
Find the magnitude of the force on each of the charges : two electric charges, eagh of+6.00μ C are placed at thecorners of the base of the square of the side s=8.50m. find the magnitude of the force on each of the charges
What is the distribution of the number of systems that : A hydrologic structure (e.g. a dam or a dike) is said to be designed for the N-year flood if it has a capacity which will be exceeded only by a flood equal oto or greater than N-year flood. The magnitude of the N-year flood is that which is exceeded ..
What is the outlet concentration after the treatment : A completely mixed retention basin is used to treat an industrial waste water consisting of a non-conservative pollutant, using a reaction that destroys the pollutant according to first-order reaction kinetics, with k = 0.216/day
What percent change in frequency results : Air Friction damps a tuning fork so that the amplitudedecreases by (1/8.1) per second. Resonance= 74 Hertz. What percent change in frequency results
What is the retention time for this lake : A small lake with volume of 20,000 m^3 has no natural pollutant sources. However, a sewage pipe discharges sewage containing an organic polluntant into the lake. Conditions in the sewage pipe are Qs= 0.5 m^3/s, and Cs= 100mg/L.
Compute the accuracy and compute the final coordinates : The Field data and the fixed data follow for each of six traverses. The forward direction is given by the alphabeteical order of the station names. Each angle is measured clockwise from the back direction to the forward direction so that  they are on..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the reaction rate constant to be first order

A reaction in a batch system is assumed to be first order. Data listed below was collected. Determine the reaction rate constant. chemical concentration (ug/L) time(min) 19.3 6

  What is the average density of the actual solids contained

a 50cm^3 sample of dry soil from an aquifer weighs 100g. when it is poured into a graduated cylinder, it displaces 35cm^3 of water. What is the porosity of the soil. What is the average density of the actual solids contained in the soil

  What is the waters temperature at the exit of the turbine

A turbine operates at steady state with steam flowing through it at a rate of 36 kg/min. The steam enters the turbine at a temperature of 600C and a pressure of 8 MPa and exits at a pressure 90% lower with a quality of 70%.

  Estimate the undrained shear strength of clay

Plot variation with depth from the top to Point C for σ' v and σ h when the soil is at rest and Estimate the undrained shear strength (c u ) of clay. (Assume the shear strengths to be 200 kPa and 2 kPa at Liquidity Index (IL) values of 0 and 1, res..

  What is the optimal life of the forklift

A 2000-pound, counterbalanced, propane forklift can be purchased for $30,000. Due to the intended service use, the forklift's market value drops 20% of its prior year's value in Years 1 and 2 and then declines by 15% until Year 10

  Determine the magnitude of the resultant hydro static force

he circular steel plate A is used to seal the opening on the water storage tank. Determine the magnitude of the resultant hydrostatic force that acts on it. Density of water = 1Mg/m^3

  What is the braking efficiency

A car is traveling up a 3% grade on a road that has good, wet pavement. The engine is running at 2500 rpm. The radius of the wheels is 15 inches, the driveline slipage is 3% and the overall gear reduction ratio is 2.5 to 1

  What is the eutectoid cementite content of the sample

You have a steel alloy with a 1.00 wt% carbon content that is cooled to room temperature. What is the eutectoid cementite content of this sample

  Find the stress induced in the aluminum rod

Find the stress induced in the aluminum rod if, after the gap is closed, the two segments are welded together, and then a leftward force is applied of the same magnitude needed to close the gap. Assume the rod segments remain aligned during loading.

  Determine the amount of moisture removed from the air

Moist air at standard conditions is at a dry bulb temperature of 80 degree F and a relative humidity of 50%. It is cooled to 50 degree F. Use the psychromtric chart to determine: a- The energy removed from the air after it is cooled in BTU/lb of d..

  Determine the maximum deflection of collar b

Collar A is dropped 30 inches onto collar B, which is resting on a spring of constant k= 4 lb/in. Assuming perfectly plastic impact (coefficient of restitution e=0), determine the maximum deflection of collar B.

  List assumptions for the other variables of the hydro logic

Estimate the amount of depression storage (inches and cubic feet) in a 6-arce parking lot using the following rainfall and discharge data. The discharge data were measured at the only outlet in the parking lot.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd