What is the distiniction b/n point and non point sources

Assignment Help Civil Engineering
Reference no: EM13210661

what is the distiniction b/n point and non point sources of water pollution and thier varation with surface and ground water?

Reference no: EM13210661

Questions Cloud

Explain reflux for reaction to be successful : The following lab requires water free conditions as well as reflux for reaction to be successful. Draw a schematic and label your reaction set up
Accumulation of information-skills and strategies learned : Which is based on the accumulation of information, skills, and strategies learned through experience, remains steady and in some cases actually improves.
Explain what is the zn cu concentration ratio : What is the Zn2+: Cu2+ concentration ratio in the following cell 25 degrees if the measured cell potential
Draw all aldehyde and ketone isomers of c6h12o : What is the reaction that occurs with hexanal and propanol (give both the hemiacetal and acetal products)?
What is the distiniction b/n point and non point sources : what is the distiniction b/n point and non point sources of water pollution and thier varation with surface and ground water?
"describing two approaches-indicators to measuring patient : "Describing two approaches or indicators to measuring patient outcomes. Measuring the quality of care is essential to being able to identify which areas of patient care need improvement.
Calculate the npv according to the divisional manager : Calculate the NPV according to the divisional manager and the NPV incorporating inflation levels to support your comments. In both cases, assume the total investment in working capital will be recovered at the end of the project.
Determine the required value for m : A 1 meter diameter cylindrical mass, M, is connected to a 2 meter wide rectangular gate. The gate is to open when the water level, h, drops below 2.5 meters. Determine the required value for M. Neglect friction at the gate hinge and pulley.
Determine the bod : A Biodegradable industrial wastewater (paper production) has a COD of 600 mg/L. If the BOD progression follows first-order kinetics with a rate constant = 0.10 per day, determine the BOD.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Wall shear stress and friction velocity

A rectangular channel 5 m wide carries a discharge of 10 m^3/s at a uniform depth of 3 m. The channel is running on a slope of 0.0025 m/m. Estimate wall shear stress and friction velocity. Assume the density of flowing water as 1000 kg/m^3.

  Components of ownership

The IIT components of ownership cost based on average annual value are: Tax-3%, Insurance -4%, and Interest-7%. a) What is the average annual value?

  Parabolic trajectory of the falling prey

A hawk flying at 2 m/s at an altitude of 45 m accidentally drops its prey. The parabolic trajectory of the falling prey is described by the equation below until it hits the ground, where y is its height above the ground and x is its horizontal dis..

  Calculate the water or cement ratio of the cement paste

Calculate the water/cement ratio of the cement paste in which all the cement will hydrate to leave no capillary pores. (density of cement: 3.1 g/cm3) ?

  Question in structure analysis

Determine axial force and Max bending - Question in structure analysis

  Darcy law and quantity of groundwater

Using Darcy's Law, calculate the quantity of groundwater (L/day), the seepage velocity (m/s), and the contaminant loading (Kg/day) to the river (assuming no retardation) for the following scenario. Be sure to include both a plane view and cross-se..

  Draw a flow net

Draw A flow net. Show flow lines, flow Channels, and Equipotential lines. Using flow nets, please provide an estimate of seepage rate below the dam. Your submittal will provide the basis for an environmental impact statement regarding the construc..

  Elastic modulus of steel

Given: elastic modulus of steel is 200 GPa, yield and ultimate tensile strength of steel are 600 and 750 MPa, respectively.

  Compression of a concrete cubes under friction

How do the crack behaves under the compression of a concrete cubes under friction between the plates and specimen with stress strain diagram?

  Determine the transformed moment of inertia for the beam

determine the transformed moment of inertia for the beam using steel as the reference material. Express your answer in in^4 to the nearest 0.1 in^4.

  Shafts in a speed-reducer unit

The two shafts in a speed-reducer unit are subjected to couples of magnitude M1 = 18 N · m and M2 = 7.5 N · m, respectively.

  What is the cumulative depreciation through the end of year

Under the 200% DB depreciation, what is the cumulative depreciation through the end of year four? The useful life of the mixing tank is 9.5 years.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd