What is the discharge of each hole

Assignment Help Civil Engineering

Reference no: EM13545660

1.A 5-m wide rectangular channel is carrying a flow of 5 cubic meter per second. If the Manning n=0.013 and the bottom slope, So=0.0001, determine the normal depth using a converging iteration. Use conveyance method to verify your result.

2.The depth of flow in a long canal with a trapezoidal across section is 2 meters. The discharge is 15 cubic meters per second with a bottom width=10m and side slopes of 1V:2H. If the discharge is increased to 20 cubic meters per second determine the new depth of flow?

3.A water of 20 c temprature pupped at 75 kpa to a perforated pipe 5 cm dia. contain 10 hole with the same diameter. the distance between two adjacent hole is 20 cm. what is the discharge of each hole?

Reference no: EM13545660

Questions Cloud

How you will place the bars and calculate the location : Concrete cover on both sides. Sketch how you will place the bars and calculate the location of the effective depth. Place as many bars in the lower layers as possible.

How many cubic yards of aggregate must be ordered for a road : How many cubic yards of aggregate must be ordered for a road base 16 inches thick and 2000 feet long with a top width of 30 ft, if the side slopes are one on one, or 45 degree?

What major differences would you expect if the water supply : A large stream flowing through a highly industrialized area must serve as the source of a community's water supply. The turbidity of the water ranges from 30 to 60 NTU, alkalinity exceeds 100 mg/L.

Determine the coliform concentration at the beach : Determine the coliform concentration at the beach. (assume that the current behaves as a plug flow reactor and that the wastewater is completely mixed in the current at the discharge point.

What is the discharge of each hole : A water of 20 c temprature pupped at 75 kpa to a perforated pipe 5 cm dia. contain 10 hole with the same diameter. the distance between two adjacent hole is 20 cm. what is the discharge of each hole?

Use the conveyance method to verify the results : A drainage channel had a cross section that may be approximated as a trapezoidal section with a bottom width of 15 feet and a side slope of 1.5H:1V. If the channel drops 2.5 feet per mile.

Determine the size of the watershed in acres and then : The 1-hr UH in the table was recorded for a particular watershed. Determine the size of the watershed in acres and then convert the 1-hr UH into a 3-hr UH for the watershed.

Determine the magnitude of the largest elastic load p that : The 10-mm-diameter steel bolt is surrounded by a bronze sleeve. the outer diameter of this sleeve is 20 mm, and its inner diameter is 10 mm. if the yield stress for the steel is

What is the maximum weight of the crate that the system can : Rope BCA passes through a pulley at point C and supports a crate at point A. Rope segment CD supports the pulley and is attached to an eye anchor embedded in a wall. Rope segment BC creates an angle of = 74.0 with the floor and rope segment CD

User Account

All Pages