Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
If a logic circuit with I_OH = 4.5 V is driving and LED with a 330 ohm limiting resistor, what is the current rating for the LED if the forward voltage drop is 1.8 V?
Draw a state diagram for an FSM (Moore machine) with no inputs and three outputs x, y, and z, where xyz should always exhibit the following sequence: 000, 001, 010, 100, repeat. Make 000 as the initial state.
Design the circuit to establish a dc emitter current of 1mA and provide the highest possible voltage gain while allowing for a maximum signal swing at the collector of +-2V. Use +10V and -5V power supplies.
1) Plot the impedance with respect fo frequency from 1Hz to 10MHz 2) Capacitor must be less than .1 of a 480 ohm resistor to be a good bypass capacitor for that resistor. What range of frequencies can we use this capacitor for
What is the peak frequency deviation of the FM signal? What is the FM improvement in dB?
An early code used in radio transmission involved using codewords that consist of binary bits and contain the same number of 1s. Thus, the 2-out-of-5 code only transmits blocks of 5 bits in which 2 bits are 1 and the others 0.
A sheet of plywood 1.39 cm thick is used to make a cabinet door 55.5 cm wide by 69.5 cm tall, with hinges mounted on the vertical edge. A small 181-g handle is mounted 45 cm from the lower hinge at the same height as that hinge.
A 415V to 11 kV transformer has a rating of 200 kVA. The winding resistance and leakage reactance when referred to the primary are 0.014 and 0.057 ohms respectively.
A parallel RLC network is constructed with a 5 mH inductor, and the remaining component values are chosen such that Q0 = 6.5 and ω0 = 1000 rad/s. Determine the approximate value of the input impedance magnitude for operation
The air feels humid. No air is coming from the registers. The air handler is in the attic. An examination of the condensing unit shows that the suction line has ice all the way back to the compressor. The compressoris still running.
Power Dissipation Problems, A signal generator outputs a sine wave signal with a frequency of 1000 Hz and an rms voltage of 20.0 V. The output of the spectrum analyzer is connected to a 200 ohm resistor.
An Air capacitor consisting of two closely spaced parallel plates has a capacitance of 1000 pF. The charge on each plate is 1 micro C. What is the potential difference between the plates. If the charge is kept constant.
A PWM is to be programmed to output a signal with a pulse high width of 150 usec and a pulse low width of 250 usec. What are the values required for prescale (if any) PWMPER and PWMDTY An 8-bit configuration is used and the E-clock is 24 MHz.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd