What is the current flowing through the galvanometer

Assignment Help Electrical Engineering
Reference no: EM13252610

1. A meter being used for a 2-wire resistance measurement has an internal current source of 1 mA. If the meter's test leads have equal resistances of 0.06 ohm, what is the measured resistance for:

a. A resistor of actual value 0.5 ohm

b. A resistor of actual value 1K ohm

2. Refer to the Wheatstone Bridge diagram attached. If the galvanometer indicates zero when R1=110ohm, R2=10ohm, and R3 is set at 2.97Kohm, what is the value of Run known ohm.

3. Refer to the Wheatstone Bridge diagram. If R1=1ohm, R2=111ohm, Runknown= 1ohm, R3 is set at 1Kohm, and the battery is 9V:

a. What is the current flowing through the galvanometer ohm Use 60ohm for the internal galvanometer resistance in calculations.

b. The measurement range of the galvanometer is +/- 500µA. What is the ratio of galvanometer current to its maximum range of 500µA

c. Is there danger of damage to the galvanometer with these resistance values

Reference no: EM13252610

Questions Cloud

What is the exit temperature : Propane enters a nozzle at 5 bar and 200ºC. It exits at a velocity of 500 m/s. At steady-state, what is the exit temperature?
Write a limerick poem : Write a limerick poem. The limerick is always light and humorous. Its usual form consists of five predominantly anapestic lines rhyming aabba
Fuel in rural locations without natural gas pipelines : LPG is a useful fuel in rural locations without natural gas pipelines.  A leak during the filling of a tank can be extremely dangerous because the vapor is denser than air and drifts to low elevations before dispersing, creating an explosion hazard.
What is the minimum amount of won : what is the minimum amount of won they should receive on August 30th, 2007 given the eight month forward rate for one US dollar in terms of won that you calculated in problem one? What is one other way they might they hedge their won/dollar exposu..
What is the current flowing through the galvanometer : Refer to the Wheatstone Bridge diagram. If R1=1ohm, R2=111ohm, Runknown= 1ohm, R3 is set at 1Kohm, and the battery is 9V:What is the current flowing through the galvanometerohm Use 60ohm for the internal galvanometer resistance in calculations.
Relative dating is determining-fossils found in strata : Are decay rates of radioactive isotopes affected by the physical and chemical environment that the isotope is in? Fossils found in strata: Relative dating is determining the
Propose a definition of innovation : 1. Propose a definition of innovation in your own words (50-100 words). 2. Compare the concepts of innovation, invention, and creativity.
Define dinitrogen pentoxide to form nitrogen dioxide : The rate constant for the decomposition of dinitrogen pentoxide to form nitrogen dioxide and oxygen gas has the rate constant 1.7 x 10-3 s-1. This is a first order reaction.
Explain the rate constant when the temperature is change : A reaction with the activation energy Ea= 219.00 kJ/mol, has a rate constant k = 2.400 x 101 at 565.00 Kelvin. Determine the rate constant when the temperature is changed to 861.00 Kelvin. R = 8.314 J K-1mol-1

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What does the sensitivity of a sensor tells about the sensor

How would you know a system is linear by just looking at its input/output characteristic graph And what does the sensitivity of a sensor tells us about the sensor

  Where should substation be located to minimize the losses

Three towns A, B & C are situated at the corners of an equivalent triangle of side 30 km. It is proposed to supply power to extent of 30 MW, 10 MW, 20 MW to A, B & C respectively from one substation. Where should substation be located to minimize ..

  Determine the steady-state error to a ramp input

Determine the relationship between the steady-state error to a ramp input and the gain K and system parameter b. For what values of K and b can we guarantee that the magnitude of the steady-state error to a ramp input

  Determine the sum of three sinusoids of frequencies

Sometimes audio (or any) signals x(t) are decomposed into a sum of sinusoids. Consider x(t) the sum of three sinusoids of frequencies 518Hz, 730Hz, and 524Hz whose amplitudes are 1/2 of their corresponding frequencies.

  Why boundary conditions are so important in electromagnetics

1. Derive boundary conditions for electric fields (both for tangential and normal components) 2. Derive boundary conditions for magnetic fields (both for tangential and normal components) 3. Why boundary conditions are so important in electromagnetic..

  Compute the battery life in years and months

An embedded system consumes the following current when in different operating modes: Operating Mode Avg. Current Time Data Acquisition 4.2 mA 1.8 ms Communication 22.6 mA 2.5 ms Sleep Mode 0.5A 5 hours

  What percentage of accounts are savings or opened

In a bank, among the accounts opened before 2005, 40% are saving accounts, 20% are chequing accounts and rest are mutual fund accounts. These numbers for accounts opened on or after 2005 are: 30% saving accounts,

  Explain c program that generates one hundred random

C program: counting numbers between 0-9, Write a C program that generates one hundred random integers between 0 and 9 and displays the count for each number.

  How many spare tubes must the building custodian maintain

The time to failure of fluorescent lights in a large office building is exponentially distributed with a failure rate of 0.03125 hours. How many spare tubes must the building custodian maintain to have at least a 0.95 probability of replacing all..

  How long a 1 inch square bar of copper have resistance

Using coppers resistivity of 10.30 CM-olm/ft at +25 °C, find how long a 1 inch square bar of copper would need be to have a resistance of 1 at +20 °C

  What is maximum positive voltage and negative voltage

what is the open- circuit voltage. power supply has isolated +- 15V and +-6V outputs,what is the maximum positive voltage and maximum negative voltage that can be output from power supply.

  Find the number of years that the country can go

find the number of years that the country can go without constructing a generating plant before the load exceeds the generating capacity. Assum a 5% annual growth rate in demand.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd