What is the corrected length of the line

Assignment Help Civil Engineering
Reference no: EM13552908

1.An in-compressible fluid flows horizontally in the x-y plane with a velocity given by u = 33 (y/h)^1/2 , where y and h are in meters and h is a constant. Determine the average velocity for the portion of the flow between y = 0 and y =h. (the answer should be between between 20-25 m/s)

2.A 100ft tape is calibrated at 68 degrees F, fully supported with 15 Ibs of tension and found to be 99.987 ft long. Is this tape is used fully supported with 15 Ibs of tension at 86 degrees F to measure a distance that is recorded as 136.48 ft, what is the corrected length of the line?

Reference no: EM13552908

Questions Cloud

Determine on a per unit mass of air flowing : An ideal Brayton refrigeration cycle has a compressor ratio of 3.75. The air enters the compressor at 1bar, 27°C. The temperature at the inlet of the turbine is 77°C. Using Air Standard Method Determine on a per unit mass of air flowing
Determine the magnitude of p : A 50-kg crate is pulled by the constant force P at an angle of 30 deg off the x axis- the crate starts from rest and achieves a speed of 10 m/s in 5 s. the coefficient of kinetic friction between the crate and ground is 0.2. Determine the magnitude o..
Assume rightward direction is positive : The 90-lb boy and 75-lb girl wald towards eachother with constant speed on a 330-lb cart with frictionless wheels. assume that the cart was at rest befor the boy and girl start walking. ith their velocities measured relative to the cart ar 4ft/s to t..
Finance the competitor through the debt market : Examine the options available to you to finance the competitor through the debt market, recommending the best alternative as a result of your analysis. Provide support for your recommendation.
What is the corrected length of the line : A 100ft tape is calibrated at 68 degrees F, fully supported with 15 Ibs of tension and found to be 99.987 ft long. Is this tape is used fully supported with 15 Ibs of tension at 86 degrees F to measure a distance that is recorded as 136.48 ft,?
How many units should be produced : How many units should be produced at this workstation per day ?
If variable y is defined obtain y in terms of c : Consider the following two simultaneous equations: x^2 + y^2 = 42x + 3*y + 2*y^2= 6 Which of the following is a possible solution for x and y? Answer x = -6.22 & y = 1.83 x = 6.48 & y = 0.18 x = -5.59 & y -1.38 x = 6.33 & y = -3.27
How do you define the direct marketing : How do you define the direct marketing ? or give some examples specific.
Executive summary of class and collaboration skills : Executive Summary of Class and Collaboration Skills

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the dry unit weight and the saturated unit weight

Calculate the dry unit weight, the saturated unit weight and the buoyant unit weight of a soil having a void ratio of 0.70 and a value of Gs of 2.72.

  Determine the pi term suitable to describe the problem

The drag force (Fd) acting on a spherical particle that falls very slowly though a viscous fluid is a function of a particle diameter, d, the particle velocity, V, and the fluid viscosity, u.

  What must the hydraulic detention time be in the aeration

Although primary and secondary sedimentation is responsible for the removal of some BOD, you will design a bioreactor which removes 85% of BOD entering the plant using an activated sludge bioreactor. Use the following values: Influent (to bioreactor)..

  What is the first order decay coefficient in day-1

A tank operated as a CFSTR used to remove benzene from a flow stream is 1500 m3 in size. The flow rate in and out of the tank is 8 m3/day. If the influent benzene concentration of 265 ug/L and the effluent concentration is 12 ug/L

  Determine the mass flow rate of nitrogen through compressor

Nitrogen is compressed from 80 kPa and 27?C to 480 kPa by a 10-kW compressor. Determine the mass flow rate of nitrogen through the compressor, assuming the compression process to be (a) isentropic

  Find elastic modulus of material used to construct the wire

Given a type of material used in a wire with diameter (d = 0.25 in) that stretches 2.3 inches while 80 feet of length is under tensile load of 1800 pounds. Find the elastic modulus of the material used to construct the wire.

  Determine true coefficient of discharge in the weir equation

A rectangular channel carries a discharge of 2.00 m3/sec per meter of channel width over a weir crest that is 1.4 m in height. The energy grade line upstream of the weir measure 2.7 m above the channel bottom

  What is the maximum step height

An open rectangular channel is 50 feet wide, flowing at a depth of 5 feet, and is carrying 1000 cubic feet per second. What is the maximum step height than can be placed into the flow without disturbing the upstream depth, without acting as a chok..

  When will drivers be able to see the full sign

A roadway has a 4% grade intersecting a -7% grade at at station 18+50.00. The grades are connected by an 800 foot vertical curve. A sign is proposed to be installed at Station 15+00.00. The bottom of the sign is 7 feet above the roadway.

  What is the rockets acceleration in meters per square

At a certain altitude and time, a rocket's acceleration is 2.5 g. One gravity (g) is equivalent to 32.2 ft/s^2. What is the rocket's acceleration in meters per square second

  Calculate the effluent concentration from the reactor

You plan to use a tank of total volume V= 10 m3 to remove a contaminant at concentration Cin = 1 g/m3 from a waste stream with a flow rate of Q = 1 m3/h. The reaction is first order with a rate constant k1 = 0.5 h-1.

  Design a bar screen for a peak average flow

design a bar screen for a peak average flow of 0.46m3/s.you can consider reasonable assumptions.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd