What is the concentration of nox

Assignment Help Civil Engineering
Reference no: EM13563800

It has been estimated that the emission of NOx from a coal fired power plant is 1300 g/s. At 100 km downwind (y=10m), what is the concentration of NOx in g/m^3. The wind speed at the top of the stack with a height of 100m is 6.5 m/s and an inversion layer of 750m

Pressure air = 95kPa

Temp. air= 25 degree C

Cloud Cover: few broken clouds (partly cloudy)

Stack temp. = 305 degree C

Diameter= 5m

Exit velocity= 1.5 m/s

time= 10:00 am summer day

plume rise = 11.7m

Reference no: EM13563800

Questions Cloud

Determine the minimum temperature in the cycle : A reversed brayton cycle operates with air entering the compressor at 1 bar and 7 c and leaving at 4 bars air enters the turbine at 37 c the compressor and the turbine efficients are 84% and 88% respectivelt determine
Estimate the value of the fuel that is captured if the vapor : Gasoline vapors are vented to the atmosphere when an underground gasoline storage tank is filled. If the tanker truck discharges into the top of the tank with no vapor control
Compute and tabulate the azimuths from the following 3-sided : Compute and tabulate the azimuths from the following 3-sided traverse where course ab is due north. angles are to the right. include a sketch.
Determine the work done and the heat transfer : Water, initially dry saturated vapour at 4 bar, lls a closed rigid con- tainer. The water is heated until its temperature is 400C. Determine the work done and the heat transfer.
What is the concentration of nox : It has been estimated that the emission of NOx from a coal fired power plant is 1300 g/s. At 100 km downwind (y=10m), what is the concentration of NOx in g/m^3. The wind speed at the top of the stack with a height of 100m is 6.5 m/s and an inversion ..
What is the maximum flowrate in the business can discharge : A business wishes to discharge salt into a river. the concentration of salt from the business is 210 mg/L. the flow of water in the river (upstream) is 0.5 m^3/s. Upstram the concentration of salt in the river 15 mg/L.
What is the theoretical rate of moisture removal : Moisture in the hot drying air condensing on the cooler grain near the plenum of the bin (Hint: The vapor in the ambient will condense out if the temperature of a surface is lower than the incoming air dew-point temperature).
Determine the station of the point where the superelevation : A 6 lane highway has 12 ft lanes and a crown cross-slope of 0.02 ft/ft. The design speed of the road is 60 mph. The station of the PC is 20+00. Determine the station of the point where th superelevation runoff begins
Find the minimum number of coins he has : According to his will: First give one coin to manager. 1/5th of the remaining to the elder son. Now give one coin to the manager and 1/5th of the remaining to second son and so on..... After giving coins to 5th son, divided the remaining coins among ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  In which the independent variable x is missing

In equation (1) notice that y plays the role of the independent variable; hence, solving it yields w(y). Then substituting w(y) into (2) we obtain a separable equation that determines y(x).

  Find modulus of elasticity of pavement for corner deflection

The pavement is on a base which has a modulus of subgrade reaction of 250 pci. A 17,000 lb corner load is applied (al is 7 inches). Using the revised Westergaard equations, find the modulus of elasticity of the pavement if a corner deflection of 0..

  Determine a set of a rectangular beam design values

Determine a set of a rectangular beam design values b,d and As that will be needed to support a factored bending moment Mu= 450 Kip-ft. Use f'c= 4500 psi and fy= 40000 psi.

  How fast is the water level rising in the reservoir per day

A reservoir with a length of 20 km and width of 3 km has a flood inflow of 1000 m^3/s. (a) If exit flow is restricted to 500 m^3/s, how fast is the water level rising in the reservoir per day

  What was the students associated perception reaction time

The student strikes the sign at a speed of 25 mi/h. if the student was travelling at 65 mi/h when the sign was first spotted, what was the student's associated perception reaction time

  What volume of supernatant is returned to the reactor

5,000 gpd of primary sludge at 5% solids (50,000 mg/l) and 5,000 gpd of biological treatment sludge (10,000 mg/l) are blended, then thickened to 8% solids. What volume of supernatant is returned to the reactor

  A small parking lot at a neighborhood park has 5 parking

A small parking lot at a neighborhood park has 5 parking spaces, and the number of occupied slots at 9 AM is a binomial random variable, with p=0.75.  If vehicle arrivals at the lot follow a poisson process, with arrival rate lambda

  Calculate the fiber weight fraction

For unidirectional carbon/epoxy tape at a 60% fiber volume fraction, calculate E11 and E22. Given Ef= 211 GPa and Em =10 GPa. Calculate the fiber weight fraction. Given pf=1.95 g/cm3 and pm =1.3 g/cm3.

  Determine the stations and elevations of pvcs and pvis

Using a design speed of 50 mi/h, determine the stations and elevations of PVCs, PVIs, and PVTs of the two vertical curves required to connect the highway segments, as well as the length of the constant grade section (connecting grade is to be as s..

  Develop a preliminary design, including flow rates

Develop a preliminary design, including flow rates, pipe sizes, and pipe slopes for a trunk sewer to be laid in the development shown in the accompanying figure from 6th to 1st Streets along Peavy Avenue.

  Pressure on the soil if theta is given

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees? Assum..

  What is the maximum internal pressure

A cylindrical pressure vessel can support an internal pressure of 2640 psi. The maximum hoop stress is (65000/2) psi and the maximum shear stress is 16000 psi. If the diameter of the tank is 7 inches,what is the minimum wall thickness. If the wall th..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd