What is the composition of the alpha phase

Assignment Help Mechanical Engineering

Reference no: EM13709600

A hypothetical A-B alloy of composition 56 wt% B-44 wt% A at some temperature is found to consist of mass fractions of 0.5 for both alpha and beta phases. If the composition of the beta phase is 88 wt% B-12 wt% A, what is the composition of the alpha phase?

Reference no: EM13709600

Questions Cloud

What is his total kinetic energy in units of btu : A skydiver with mass of 175 pounds is falling at a velocity of 50.0 meters per second. What is his total kinetic energy in units of Btu? Determine the amount of energy required to accelerate a 1225 kg car from 10.0 to 60.0 km/h on an uphill road with..

Administer fluids and drugs rapidly : Physicians often use IV lines to administer fluids and drugs rapidly. The rate of application of the IV fluid is determined to some extent by the height of the IV bag above the patient. Assume that the IV line enters the patient through her venous sy..

Typical towns in states with big plains like texas : Typical towns in states with big plains like Texas need an elevated tank to supply tap water. Below there is a picture of a typical elevated tank. If we approximate the tank as a cylinder with a diameter of 50 ft and a height of 25 ft, answer the fol..

Calculate the heat transfer per unit mass of water : Water enters a boiler at 160 psia as a saturated liquid and leaves at 600 degree F at the same pressure. Calculate the heat transfer per unit mass of water.

What is the composition of the alpha phase : A hypothetical A-B alloy of composition 56 wt% B-44 wt% A at some temperature is found to consist of mass fractions of 0.5 for both alpha and beta phases. If the composition of the beta phase is 88 wt% B-12 wt% A, what is the composition of the alpha..

Find the initial pressure and mass of the system : Water in the pictured piston cylinder assembly has an initial quality of 10%. The piston cylinder is 20 cm in width and the piston is initially 40 cm high. Heat is added until the temperature of the steam reaches 500°C. While heat is being added the ..

Steam flows steadily through an adiabatic turbine : Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 10MPa, 450C and 83 m/s, and the exit conditions are 10kPa, 92 percent and 42 m/s. The mass flow rate of the steam is 12 kg/s.

The initial and final phase descriptions of the water : One-half kilogram of pure water is heated in a frictionless piston-cylinder device, at a constant pressure of 200 kPa, from an initial temperature of 20oC to a final temperature of 400oC.

Kinetic energy of the air within the chamber is negligible : An air cushion vehicle is supported by forcing air into the chamber created by a skirt around the periphery of the vehicle as shown in Fig. P3.106. The air escapes through the 1.7-in. clearance between the lower end of the skirt and the ground (or wa..

User Account

All Pages