Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Suppose in Fig. 3.43, the diodes carry a current of 5 mA and the load, a current of 20 mA. If the load current increases to 21 mA, what is the change in the total voltage across the three diodes? Assume R1 is much greater than 3rd.
A 50 Hz, 440 V, 3-phase , 4-pole induction motor develops half the rated torque at 1490 r.p.m. with the applied voltage magnitude remaining at the rated value, what should be its frequency if the motor has to develop the same torque at 1550 r.p.m.
A circuit consists of a battery connected to three resistors (60ohm , 30ohm , and 180ohm ) in parallel. The total current through the resistors is 1.9A . Find the emf of the battery.
Design the datapath that will add the value in register A to the value in any of the registers R0 through R3 and store the result back into any of the registers R0 through R3. The inputs to the datapath should be two-bit control signals src and de..
Consider LTI system S with impulse response h(t) = u(t) - u(t-2). A) Let x1(t) = d/dt(u(t) - u(t-2)). What is the output of the system B) Let x2(t) = cos(pi*t). What is the output of the system
What are the advantages of a current controlled device over a voltage controlled device , and advantages of 4-20mA loop over a closed loop voltage
A linear time-invariant continuous-time system responds to the following inputs with the corresponding outputs:Ifx(t) = u(t), then y(t) = 2(1- e^-t)u(t) and if x(t) = cost,then y(t) = 1.414 cos(t - pi/4).
what is the common mode of starting the synchronous motor. Explain the function of the damper winding popularly called as the "amortisseur winding". Indicate all circuit diagrams to explain working of the synchronous motor.
If a silicon diffusion is doped with phosphorus (donors) at a concentration of 1.0 x 10^16/cm^3, and has a sheet resistance of 365.7 ohm/cm^2 square, what is the thickness of the diffusion in microns
An M-bit thermometer code for the number k consists of k 1s in theleast significant bit positions and M-k 0s in the more significant bit positions. A binary-to-thermometer code converter has N inputs and 2N-1 outputs.
A transformer has a primary windings of 800 turns and a secondary windings of 200 turns. When the load current on secondary is 80 A at 0.8 p.f, lagging, the primary current is 25 A at 0.707 p.f. lagging.
A HCS12 embedded timer is in PWM mode. If the E-clock is 24 MHz, and a scaler value of 16 is selected, what is the period for a signal with PWMPER = 0x75
Make sure to mark significant points in your figure (amplitude, offset, time, etc.). How could a device be modified to work as an electro-optic phase modulator? If we apply signal V, what is the range of phase shifts induced by this modulator.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd